Locate Studs and Drill Pilot Holes
From How to Find Studs and Set the Right Handrail Height · Step 4 of 5 · Video by This Old House

Showing 1:47–2:15 of the source video. Watch the full video with every moment.
What happens in this clip
Once the chalk line is established, use a stud finder to locate the studs behind the wall. Run the stud finder along the chalk line to identify the edges of each stud. Mark the center of the stud where you intend to place each bracket. Using a 7/64-inch drill bit, drill pilot holes at these marked locations. These pilot holes will guide the screws and prevent wood splitting when mounting the brackets.
Goal: Use a stud finder to locate wall studs along the chalk line and drill pilot holes for the handrail brackets.
What's used
Tools
- 7/64-inch Drill Bit
- Cordless Drill
- Marker
- Stud Finder
About the full video
This video provides a detailed guide on installing a wooden handrail along a staircase, adhering to building code height requirements. It covers essential steps from accurately marking the wall for bracket placement and cutting the railing to size, to attaching mitered returns and finally mounting the railing securely to the wall.
Step 4 of 5: Drill Pilot Holes
Select a drill bit that is slightly smaller than the diameter of the screws you will be using for the brackets. At each marked screw location, drill a pilot hole into the center of the wall stud. Drill to a depth sufficient for the screw to engage the stud securely.
Every video in How to Find Studs and Set the Right Handrail Height
Step 1: Determine Handrail Height
- 0:47–1:58 Mark Handrail Height
- 0:40–1:07 Measure Handrail Height
- 3:48–4:29 Verify Handrail Height for Code Compliance
Step 2: Locate Wall Studs
- 3:11–4:40 Utilize an Electronic Stud Finder and Mount Item
- 0:34–1:16 Locate and Mark Studs with Stud Finder
- 0:04–0:13 Locate Wall Studs
Step 3: Mark Support Bracket Locations
- 1:25–2:44 Install Handrail Brackets (Wood Studs)
- 2:22–2:54 Mark Screw Locations
- 2:46–3:44 Locate and Mark Studs for Brackets
Step 4: Drill Pilot Holes
- 1:47–2:15 Locate Studs and Drill Pilot Holes (this video)
- 0:31–0:38 Drill Pilot Holes
- 8:51–9:40 Pre-Drill Pilot Holes
Step 5: Attach Support Brackets
- 0:23–0:35 Install Handrail Brackets
- 2:28–2:44 Install Brackets and Mount Handrail
- 2:15–2:28 Mount Handrail Brackets
How to Find Studs and Set the Right Handrail Height
This project outlines the steps to locate wall studs and determine the correct height for installing a handrail, ensuring safety and code compliance for stairways and accessible routes.
Read the full guide Browse all guides
Planning this project? Shop Oak Valley Designs.

