Locate Wall Studs
From How to Find Studs and Set the Right Handrail Height · Step 2 of 5 · Video by CR Carpentry & Remodeling

Showing 0:04–0:13 of the source video. Watch the full video with every moment.
What happens in this clip
Begin by removing any existing TV or furniture from the wall. Then, use a stud finder, specifically a Zircon Edge Finding stud finder as shown in the video, to locate the wooden studs within the wall. Once a stud is detected, mark its edges with a pencil directly on the wall or on a piece of painter's tape placed horizontally on the wall. This ensures accurate placement of the TV mount's lag screws, providing a secure anchor point.
Goal: Identify and mark the locations of wall studs for secure mounting.
What's used
Tools
- Painter's Tape
- Pencil
- Zircon Edge Finding Stud Finder Zircon
- Advanced electronic stud finder
About the full video
This project guides you through the process of securely mounting a television to a wall, including how to locate wall studs, install a full-motion TV mount, and hide cables using an in-wall cable management system for a clean and professional look.
Step 2 of 5: Locate Wall Studs
At each marked height, use an electronic stud finder to locate the vertical wall studs. Once a stud is detected, slide the finder horizontally to find its edges and then mark the centerlines of the studs. Repeat this process for all desired mounting locations.
Every video in How to Find Studs and Set the Right Handrail Height
Step 1: Determine Handrail Height
- 0:47–1:58 Mark Handrail Height
- 0:40–1:07 Measure Handrail Height
- 3:48–4:29 Verify Handrail Height for Code Compliance
Step 2: Locate Wall Studs
- 3:11–4:40 Utilize an Electronic Stud Finder and Mount Item
- 0:34–1:16 Locate and Mark Studs with Stud Finder
- 0:04–0:13 Locate Wall Studs (this video)
Step 3: Mark Support Bracket Locations
- 1:25–2:44 Install Handrail Brackets (Wood Studs)
- 2:22–2:54 Mark Screw Locations
- 2:46–3:44 Locate and Mark Studs for Brackets
Step 4: Drill Pilot Holes
- 1:47–2:15 Locate Studs and Drill Pilot Holes
- 0:31–0:38 Drill Pilot Holes
- 8:51–9:40 Pre-Drill Pilot Holes
Step 5: Attach Support Brackets
- 0:23–0:35 Install Handrail Brackets
- 2:28–2:44 Install Brackets and Mount Handrail
- 2:15–2:28 Mount Handrail Brackets
How to Find Studs and Set the Right Handrail Height
This project outlines the steps to locate wall studs and determine the correct height for installing a handrail, ensuring safety and code compliance for stairways and accessible routes.
Read the full guide Browse all guides
Planning this project? Shop Oak Valley Designs.

