Verify and Clean Up
From How to Fix a Squeaky Floor on a Stair Landing · Step 5 of 5 · Video by Cody Steck

Showing 0:38–0:54 of the source video. Watch the full video with every moment.
What happens in this clip
After the screw head has snapped off, carefully remove any small pieces of the broken screw head or sawdust from the floor surface. Then, step firmly on the previously squeaky area to test if the repair has been successful. If the squeak persists or if another squeaky spot is detected nearby, repeat the process from Step 2 (locating the joist) and install additional screws as necessary until the floor is silent.
Goal: Confirm the squeak is eliminated and clean the work area.
About the full video
This DIY project provides a simple and effective method to eliminate squeaks in wooden flooring. It involves identifying the problematic areas, locating the underlying subfloor joists, drilling pilot holes, and then using specialized screws that snap off below the surface to secure the floorboards to the joists, effectively stopping the squeaking.
Step 5 of 5: Test and Finish
The final step is to confirm that the repair was successful. Test the area thoroughly by walking on it in different spots and with varying pressure. If the squeak is gone, clean up any dust or debris from the repair process. If the problem isn't fixed, it may require a more in-depth diagnosis or the assistance of a professional carpenter.
Every video in How to Fix a Squeaky Floor on a Stair Landing
Step 1: Locate Squeak Source
- 0:00–0:09 Locate the Squeak
- 0:55–1:16 Locate and Mark the Squeaky Area
- 0:13–0:20 Locate Squeaky Floor Section
Step 2: Test Lubrication Method
- 0:34–0:54 Apply Dry Lubricant to Eliminate Squeaks
- 0:52–2:39 Apply Powder
- 0:45–0:54 Apply Talcum Powder to Squeaky Area
Step 3: Secure Loose Floorboards
Step 4: Reinforce Subfloor or Joists
- 2:59–4:16 Fix from Below: Use Shims
- 5:35–7:36 Option 1: Shim the Joist
- 0:05–0:10 Insert Shims to Fill Gaps
Step 5: Test and Finish
- 9:40–9:57 Final Check and Confirmation
- 0:23–0:28 Test and Verify Results
- 0:38–0:54 Verify and Clean Up (this video)
How to Fix a Squeaky Floor on a Stair Landing
This project outlines the steps to diagnose and fix a squeaky floor on a stair landing. It involves identifying the source of the squeak, which is typically friction between floorboards, subfloor, or joists, and then applying a solution to eliminate the noise. Solutions can range from simple lubrication to more involved fastening.
Read the full guide Browse all guides
Planning this project? Shop Oak Valley Designs.

