Secure Subfloor to Joists with Screws
From How to Fix a Squeaky Floor on a Stair Landing · Step 3 of 5 · Video by Today's Homeowner with Danny Lipford

Showing 0:36–0:52 of the source video. Watch the full video with every moment.
What happens in this clip
Using a cordless drill, drive 2 or 3-inch long wood screws with countersink heads through the subfloor and into the floor joists. Position these screws along the chalk lines, ensuring they go directly into the joist. Focus on the areas previously marked as squeaky. Countersink the screw heads so they are flush with or slightly below the subfloor surface. This secures the subfloor firmly to the joists, preventing movement that causes squeaks, and unlike nails, screws will not pull out over time.
Goal: Eliminate squeaks caused by loose subfloor movement.
What's used
Tools
- Cordless Drill DeWalt
- Impact driver
- Driver Bit
Materials
- Wood Screws
About the full video
This project provides a guide on how to fix squeaky floors that are covered by carpet. The process involves carefully pulling back the carpet and pad, identifying the source of the squeaks by locating loose subfloor areas and floor joists, securing the subfloor with screws, and optionally gluing plywood seams. Finally, the carpet is professionally re-stretched and re-seamed.
Step 3 of 5: Secure Loose Floorboards
This step addresses squeaks caused by movement between the floorboard and the subfloor, or between the subfloor and the joists. By fastening the layers together, you eliminate the potential for shifting and rubbing. Predrilling pilot holes can help prevent the wood from splitting and make driving the screws easier. Countersinking the screw heads slightly will allow them to be hidden later.
Every video in How to Fix a Squeaky Floor on a Stair Landing
Step 1: Locate Squeak Source
- 0:00–0:09 Locate the Squeak
- 0:55–1:16 Locate and Mark the Squeaky Area
- 0:13–0:20 Locate Squeaky Floor Section
Step 2: Test Lubrication Method
- 0:34–0:54 Apply Dry Lubricant to Eliminate Squeaks
- 0:52–2:39 Apply Powder
- 0:45–0:54 Apply Talcum Powder to Squeaky Area
Step 3: Secure Loose Floorboards
- 0:36–0:52 Secure Subfloor to Joists with Screws (this video)
- 6:00–7:07 Secure Floorboard and Countersink
- 0:39–0:44 Fix Squeaks Between Floor and Subfloor (Access from Below)
Step 4: Reinforce Subfloor or Joists
- 2:59–4:16 Fix from Below: Use Shims
- 5:35–7:36 Option 1: Shim the Joist
- 0:05–0:10 Insert Shims to Fill Gaps
Step 5: Test and Finish
- 9:40–9:57 Final Check and Confirmation
- 0:23–0:28 Test and Verify Results
- 0:38–0:54 Verify and Clean Up
How to Fix a Squeaky Floor on a Stair Landing
This project outlines the steps to diagnose and fix a squeaky floor on a stair landing. It involves identifying the source of the squeak, which is typically friction between floorboards, subfloor, or joists, and then applying a solution to eliminate the noise. Solutions can range from simple lubrication to more involved fastening.
Read the full guide Browse all guides
Planning this project? Shop Oak Valley Designs.

