Option 1: Shim the Joist
From How to Fix a Squeaky Floor on a Stair Landing · Step 4 of 5 · Video by Skill Builder

Showing 5:35–7:36 of the source video. Watch the full video with every moment.
What happens in this clip
If choosing to shim, select shims made of steel or hard wood (avoid soft wood that can compress over time). Carefully tap one or more shims into the gap between the underside of the loose joist end and the top surface of the steel beam. The goal is to fill the void completely and tightly, preventing any vertical movement of the joist. This may require some effort, and a hammer is typically used to gently, but firmly, drive the shims into place until the joist is secure. Ensure the shims are stable and do not shift when pressure is applied to the joist.
Goal: Insert durable shims underneath the loose joist end, directly on top of the supporting steel beam, to eliminate vertical movement.
What's used
Tools
- Hammer
- Steel Shims
About the full video
This project details how to stabilize a loose floor joist that is causing squeaks and nail protrusion through the ceiling below. The primary issue is a joist end that is floating above its supporting steel beam. Two main methods are discussed and demonstrated: using shims or applying expanding polyurethane foam to eliminate the vertical movement and secure the joist, thereby reinforcing the subfloor and preventing future squeaks.
Step 4 of 5: Reinforce Subfloor or Joists
This is a more involved repair that requires access to the underside of the floor. Shimming fills voids that allow movement, while blocking (or bracing) adds structural rigidity to the joists themselves, preventing excessive flex. Ensure any shims are made of hardwood and are snug, and that blocking is securely fastened to the joists.
Every video in How to Fix a Squeaky Floor on a Stair Landing
Step 1: Locate Squeak Source
- 0:00–0:09 Locate the Squeak
- 0:55–1:16 Locate and Mark the Squeaky Area
- 0:13–0:20 Locate Squeaky Floor Section
Step 2: Test Lubrication Method
- 0:34–0:54 Apply Dry Lubricant to Eliminate Squeaks
- 0:52–2:39 Apply Powder
- 0:45–0:54 Apply Talcum Powder to Squeaky Area
Step 3: Secure Loose Floorboards
Step 4: Reinforce Subfloor or Joists
- 2:59–4:16 Fix from Below: Use Shims
- 5:35–7:36 Option 1: Shim the Joist (this video)
- 0:05–0:10 Insert Shims to Fill Gaps
Step 5: Test and Finish
- 9:40–9:57 Final Check and Confirmation
- 0:23–0:28 Test and Verify Results
- 0:38–0:54 Verify and Clean Up
How to Fix a Squeaky Floor on a Stair Landing
This project outlines the steps to diagnose and fix a squeaky floor on a stair landing. It involves identifying the source of the squeak, which is typically friction between floorboards, subfloor, or joists, and then applying a solution to eliminate the noise. Solutions can range from simple lubrication to more involved fastening.
Read the full guide Browse all guides
Planning this project? Shop Oak Valley Designs.

