Fix from Below: Use Shims
From How to Fix a Squeaky Floor on a Stair Landing · Step 4 of 5 · Video by RealHouseDIY

Showing 2:59–4:16 of the source video. Watch the full video with every moment.
What happens in this clip
To fix a squeak caused by a subfloor-to-joist gap, especially if accessing from below, use shims. Insert one or more shims into the gap between the subfloor and the joist until the gap is completely closed and the subfloor is snug against the joist. The key is to avoid hammering the shims; they should be pushed in only as far as necessary by hand. Hammering can over-tighten, creating a hump in the floor above.
Goal: Eliminate the gap between the subfloor and joist from below using shims.
What's used
Tools
- Shims Unknown (plastic shown)
- Metal shims
About the full video
This DIY project provides a comprehensive guide to identifying and fixing squeaky floors, addressing common causes like buckled finished flooring and gaps between subfloors and joists. The instructions cover techniques for fixing squeaks from above (using screws) and from below (using shims), with a detailed demonstration of applying shims from a basement to eliminate a specific floor squeak.
Step 4 of 5: Reinforce Subfloor or Joists
This is a more involved repair that requires access to the underside of the floor. Shimming fills voids that allow movement, while blocking (or bracing) adds structural rigidity to the joists themselves, preventing excessive flex. Ensure any shims are made of hardwood and are snug, and that blocking is securely fastened to the joists.
Every video in How to Fix a Squeaky Floor on a Stair Landing
Step 1: Locate Squeak Source
- 0:00–0:09 Locate the Squeak
- 0:55–1:16 Locate and Mark the Squeaky Area
- 0:13–0:20 Locate Squeaky Floor Section
Step 2: Test Lubrication Method
- 0:34–0:54 Apply Dry Lubricant to Eliminate Squeaks
- 0:52–2:39 Apply Powder
- 0:45–0:54 Apply Talcum Powder to Squeaky Area
Step 3: Secure Loose Floorboards
Step 4: Reinforce Subfloor or Joists
- 2:59–4:16 Fix from Below: Use Shims (this video)
- 5:35–7:36 Option 1: Shim the Joist
- 0:05–0:10 Insert Shims to Fill Gaps
Step 5: Test and Finish
- 9:40–9:57 Final Check and Confirmation
- 0:23–0:28 Test and Verify Results
- 0:38–0:54 Verify and Clean Up
How to Fix a Squeaky Floor on a Stair Landing
This project outlines the steps to diagnose and fix a squeaky floor on a stair landing. It involves identifying the source of the squeak, which is typically friction between floorboards, subfloor, or joists, and then applying a solution to eliminate the noise. Solutions can range from simple lubrication to more involved fastening.
Read the full guide Browse all guides
Planning this project? Shop Oak Valley Designs.

