Remove Old Fixture and Wiring
From How to Replace a Flush-Mount Ceiling Light on a Stair Landing · Step 2 of 6 · Video by Phil Crockett

Showing 0:39–1:37 of the source video. Watch the full video with every moment.
What happens in this clip
Once the power is confirmed off, begin removing the old light fixture. Many flush mount lights have an outer housing secured by screws, usually located on the sides or bottom. For this fixture, a single screw was removed to detach the main light housing. After the housing is off, you will see an internal mounting plate and the electrical wires connected with wire nuts. Disconnect these wires carefully, noting their colors (black for hot, white for neutral, bare for ground). In this case, an extra red hot wire was present and needed to be capped and tucked away, as it was not needed for the new fixture. Finally, remove the old mounting bracket from the electrical box by unscrewing it.
Goal: Detach and remove the old light fixture and its mounting hardware.
What's used
Tools
- Electrical Tape
- Screwdriver (Phillips or flathead)
- Wire Nuts
About the full video
This project details the process of replacing an old, dual-lamp deck light with a new LED square ceiling flush mount outdoor light. It covers safety precautions like checking for voltage and turning off power, dismantling the old fixture, preparing and assembling the new fixture, correctly wiring it to the house's electrical system, and securing it into place. Special attention is given to adapting to existing electrical box conditions, such as a shallow box and an extra hot wire.
Step 2 of 6: Remove the old light fixture
Once power is confirmed off, inspect how the current fixture is attached. Most flush-mount fixtures are held by screws, clips, or a threaded center nut. Remove any decorative covers or shades. Unscrew or unclip the fixture from the mounting bracket. Support the fixture as you disconnect the wiring. Remove wire nuts connecting the fixture wires to the house wiring, and carefully separate the wires.
Every video in How to Replace a Flush-Mount Ceiling Light on a Stair Landing
Step 1: Turn off power at the breaker
- 0:42–0:49 Turn Off Power at Circuit Breaker
- 0:50–1:05 Turn Off Power at Circuit Breaker
- 0:10–0:12 Turn Off Power at Circuit Breaker
Step 2: Remove the old light fixture
- 0:39–1:37 Remove Old Fixture and Wiring (this video)
- 0:11–0:30 Turn Off Power & Remove Old Fixture
- 0:38–1:17 Remove Old Light Fixture and Bracket
Step 3: Install the new fixture's mounting bracket
- 3:51–4:53 Remove Old Mounting Bracket and Install New One
- 1:17–1:30 Replace Mounting Bracket
- 0:40–0:42 Install Mounting Bracket
Step 4: Wire the new light fixture
- 0:54–1:04 Attach New Fixture Wires
- 2:46–3:50 Connect New Light Fixture Wiring
- 6:28–7:18 Connect New Fixture's Electrical Wires
Step 5: Mount the new fixture and attach covers
- 1:04–1:17 Mount New Fixture Base
- 2:29–2:55 Mount the Fixture and Attach Shade
- 2:29–2:55 Mount the Fixture and Attach Shade
Step 6: Restore power and test the new fixture
- 10:35–10:39 Restore Power and Test the New Fixtures
- 5:24–5:39 Restore Power and Test
- 5:02–5:17 Restore Power and Test Light
How to Replace a Flush-Mount Ceiling Light on a Stair Landing
Outline for replacing a flush-mount ceiling light fixture on a stair landing, covering safety precautions, fixture removal, new fixture installation, and testing.
Read the full guide Browse all guides
Planning this project? Shop Oak Valley Designs.

