Remove The Old Fixture
From How to Replace a Light Fixture over a Two-Story Stairwell · Step 2 of 4 · Video by Family Handyman

Showing 0:10–0:28 of the source video. Watch the full video with every moment.
What happens in this clip
Begin by removing any decorative glass shades or covers from the old fixture to prevent accidental breakage. Unscrew the light bulbs. Use a screwdriver to detach the fixture's base or canopy from the ceiling electrical box. Once loose, carefully lower the fixture to expose the electrical wiring. Before touching any wires, use a non-contact voltage tester to confirm that the power is indeed off at the wires inside the electrical box. Disconnect the wires by untwisting the wire nuts: usually black (hot), white (neutral), and a bare copper or green wire (ground). Finally, remove the old mounting bracket from the electrical box. Inspect the ceiling area; if the old fixture left unpainted patches or damaged plaster, you may need to do some touch-up painting before installing the new fixture.
Goal: Carefully dismantle and remove the existing light fixture from the ceiling, including any glass components and wiring connections.
What's used
Tools
- Foam Brush
- Non-Contact Voltage Tester
- Paint
- Screwdriver
- Wire Nuts
About the full video
This project provides a comprehensive guide on how to safely replace an existing light fixture with a new one, covering essential steps from disconnecting power to making secure electrical connections and final assembly.
Step 2 of 4: Remove the Old Light Fixture
With the power confirmed off, remove any decorative globes or covers from the old fixture. Unscrew the mounting screws that hold the fixture's base to the ceiling electrical box. Support the fixture as you disconnect the wires. Typically, you'll find black (hot), white (neutral), and green or bare copper (ground) wires. Unscrew wire nuts or use pliers to gently untwist the wire connections. Ensure the wires do not fall back into the electrical box.
Every video in How to Replace a Light Fixture over a Two-Story Stairwell
Step 1: De-energize the Circuit
- 0:50–1:05 Turn Off Power at Circuit Breaker
- 0:31–0:40 Turn Off Power at Breaker
- 0:03–0:05 Shut Off Power to the Circuit
Step 2: Remove the Old Light Fixture
- 0:10–0:28 Remove The Old Fixture (this video)
- 0:22–0:34 Remove Old Light Fixture
- 0:02–0:04 Remove Existing Light Fixture
Step 3: Install the New Light Fixture
- 2:46–3:50 Connect New Light Fixture Wiring
- 1:30–1:53 Wire and Hang New Fixture
- 4:35–5:33 Install Mounting Bracket and Safety Wire
Step 4: Restore Power and Test
- 5:24–5:39 Restore Power and Test
- 10:35–10:39 Restore Power and Test the New Fixtures
- 0:16–0:25 Restore Power and Final Check
How to Replace a Light Fixture over a Two-Story Stairwell
This project outlines the steps for safely replacing a light fixture in a two-story stairwell. It involves gathering necessary tools and materials, safely de-energizing the circuit, removing the old fixture, installing the new fixture, and restoring power.
Read the full guide Browse all guides
Planning this project? Shop Oak Valley Designs.

