Install Mounting Bracket and Safety Wire
From How to Replace a Light Fixture over a Two-Story Stairwell · Step 3 of 4 · Video by How To Home

Showing 4:35–5:33 of the source video. Watch the full video with every moment.
What happens in this clip
Pull the electrical wires fully through the decorative top box plate (canopy) of the new fixture. This plate will cover the electrical junction box on the ceiling. Position the light fixture onto the pre-stacked boxes, similar to how the old fixture was supported, to provide support while you work on the ceiling. Next, mount the new crossbar/mounting bracket supplied with the new fixture to the electrical junction box in the ceiling using screws. Ensure the screws are not fully tightened yet. The bracket often has slotted channels, allowing for slight adjustments to perfectly square up the light fixture later, if needed. Finally, attach the safety wire/hook from the light fixture to the mounting bracket. This will temporarily support the fixture during wiring, preventing it from falling and freeing your hands.
Goal: Secure the mounting bracket to the ceiling and attach the safety wire for the new fixture.
What's used
Tools
- Cordless Drill Milwaukee
- New Mounting Bracket (Crossbar)
- Safety Hook/Wire
- Screws
- Stacked Boxes
- Adjustable work platform
About the full video
This project guides you through the process of replacing an old 'builder-grade' hanging light fixture with a new, more stylish one. It covers safe removal of the old fixture, assembly of the new light, electrical wiring, and final mounting, resulting in an updated and brighter room aesthetic.
Step 3 of 4: Install the New Light Fixture
Refer to the new fixture's installation manual. Usually, you'll attach a mounting bracket to the electrical box. Then, connect the wires from the ceiling to the corresponding wires on the new fixture (e.g., black to black, white to white, ground to ground). Use the provided wire nuts to secure the connections. Gently tuck the wires back into the electrical box. Finally, attach the new fixture's base to the mounting bracket and install any bulbs and decorative components.
Every video in How to Replace a Light Fixture over a Two-Story Stairwell
Step 1: De-energize the Circuit
- 0:50–1:05 Turn Off Power at Circuit Breaker
- 0:31–0:40 Turn Off Power at Breaker
- 0:03–0:05 Shut Off Power to the Circuit
Step 2: Remove the Old Light Fixture
- 0:10–0:28 Remove The Old Fixture
- 0:22–0:34 Remove Old Light Fixture
- 0:02–0:04 Remove Existing Light Fixture
Step 3: Install the New Light Fixture
- 2:46–3:50 Connect New Light Fixture Wiring
- 1:30–1:53 Wire and Hang New Fixture
- 4:35–5:33 Install Mounting Bracket and Safety Wire (this video)
Step 4: Restore Power and Test
- 5:24–5:39 Restore Power and Test
- 10:35–10:39 Restore Power and Test the New Fixtures
- 0:16–0:25 Restore Power and Final Check
How to Replace a Light Fixture over a Two-Story Stairwell
This project outlines the steps for safely replacing a light fixture in a two-story stairwell. It involves gathering necessary tools and materials, safely de-energizing the circuit, removing the old fixture, installing the new fixture, and restoring power.
Read the full guide Browse all guides
Planning this project? Shop Oak Valley Designs.

