Shut Off Power to the Circuit
From How to Replace a Light Fixture over a Two-Story Stairwell · Step 1 of 4 · Video by Family Handyman

Showing 0:03–0:05 of the source video. Watch the full video with every moment.
What happens in this clip
Before beginning any work on the light fixture, locate the electrical panel (breaker box) in your home. Identify the circuit breaker that controls the power to the light fixture you intend to remove. Flip the switch on this specific circuit breaker to the 'OFF' position to cut off all electrical current to the fixture. This is a crucial first step for safety, preventing accidental electrocution.
Goal: Safely de-energize the circuit connected to the light fixture.
What's used
Tools
- Electrical Panel/Breaker Box
About the full video
This video provides a step-by-step guide on how to safely disconnect and remove an existing ceiling light fixture, highlighting the critical importance of cutting power at the circuit breaker and verifying electrical safety. It then demonstrates the subsequent installation of a new light fixture, showcasing the complete replacement process from start to finish.
Step 1 of 4: De-energize the Circuit
Go to your home's electrical panel. Identify the breaker that controls the light fixture in the stairwell. Flip the breaker to the 'off' position. To ensure the power is completely off, use a non-contact voltage tester near the existing fixture's wiring after removing the old fixture's cover. This is a critical safety step.
Every video in How to Replace a Light Fixture over a Two-Story Stairwell
Step 1: De-energize the Circuit
- 0:50–1:05 Turn Off Power at Circuit Breaker
- 0:31–0:40 Turn Off Power at Breaker
- 0:03–0:05 Shut Off Power to the Circuit (this video)
Step 2: Remove the Old Light Fixture
- 0:10–0:28 Remove The Old Fixture
- 0:22–0:34 Remove Old Light Fixture
- 0:02–0:04 Remove Existing Light Fixture
Step 3: Install the New Light Fixture
- 2:46–3:50 Connect New Light Fixture Wiring
- 1:30–1:53 Wire and Hang New Fixture
- 4:35–5:33 Install Mounting Bracket and Safety Wire
Step 4: Restore Power and Test
- 5:24–5:39 Restore Power and Test
- 10:35–10:39 Restore Power and Test the New Fixtures
- 0:16–0:25 Restore Power and Final Check
How to Replace a Light Fixture over a Two-Story Stairwell
This project outlines the steps for safely replacing a light fixture in a two-story stairwell. It involves gathering necessary tools and materials, safely de-energizing the circuit, removing the old fixture, installing the new fixture, and restoring power.
Read the full guide Browse all guides
Planning this project? Shop Oak Valley Designs.

