Connect LED Controller to Power Supply
From How to Connect LED Light Strips to a Controller and Power Supply · Step 2 of 4 · Video by Siwelo Lighting

Showing 0:05–0:12 of the source video. Watch the full video with every moment.
What happens in this clip
Locate the power input terminals on the LED controller (labeled 'POWER') and the output terminals on the LED Profile Power Supply. The video shows two main power wires (red and blue) extending from the LED controller's power input. Connect the red wire from the LED controller to the positive (+) screw terminal on the power supply. Connect the blue wire from the LED controller to the negative (-) screw terminal on the power supply. Ensure all connections are secure by tightening the screw terminals. This step is crucial for providing DC power from the PSU to the LED controller, which then powers the LED strip.
What's used
Tools
- LED Controller
- LED Profile Power Supply (PSU)
- Screwdriver (Small flathead or Philips)
- Wires (Red
- Blue)
About the full video
This video demonstrates the connection of an LED strip light system, including an LED strip, an LED controller, and a power supply unit (PSU). It shows the final wiring steps to connect the LED controller to the power supply via screw terminals and then powers on the system to showcase the LED strip's functionality.
Step 2 of 4: Connect Controller to Power Supply
Identify the power input connector on the LED controller. This is usually a barrel jack or a pair of screw terminals labeled 'DC IN', '+/-', or similar. Locate the output connector from your power supply. This might be a barrel plug or bare wires. Connect the power supply's output to the controller's input. If using a barrel plug, ensure it matches the controller's jack size and that the center pin is positive (+) and the outer sleeve is negative (-), or vice-versa, as specified by the controller. If using screw terminals or bare wires, connect the positive (+) wire from the power supply to the positive (+) terminal on the controller and the negative (-) wire to the negative (-) terminal. Double-check the voltage rating of both the power supply and the controller to ensure they are compatible (e.g., both 12V or both 24V).
Every video in How to Connect LED Light Strips to a Controller and Power Supply
Step 1: Connect LED Strips to Controller
- 0:20–0:23 Connect LED Light Strips to Controller
- 0:27–0:42 Connect LED Strips to Controller
- 4:49–5:59 Connect LED Strip to Controller
Step 2: Connect Controller to Power Supply
- 0:05–0:12 Connect LED Controller to Power Supply (this video)
- 0:23–0:34 Connect Power Adapter to LED Controller
- 0:09–0:12 Connect Power Supply to LED Controller
Step 3: Test the Lighting System
- 1:11–1:33 Power Up and Test
- 0:12–0:15 Power On and Test LED Strip
- 1:20–1:50 Power On and Initial Test
Step 4: Mount LED Strips and Controller
- 0:01–0:07 Mount the LED Strips
- 0:01–0:02 Mount the LED Controller
- 6:21–7:00 Mount LED Strip and Consider Extrusion
How to Connect LED Light Strips to a Controller and Power Supply
This project outlines the steps for connecting LED light strips to a controller and power supply for a DIY lighting setup.
Read the full guide Browse all guides
Planning this project? Shop Oak Valley Designs.

