Prepare Damaged Concrete and Install Forms
From How to Fix a Crumbling Concrete Step Corner · Step 2 of 6 · Video by Today's Homeowner with Danny Lipford

Showing 0:43–1:02 of the source video. Watch the full video with every moment.
What happens in this clip
Prepare the damaged concrete surfaces by removing any loose or deteriorated material. Use a chisel and a hammer to chip away loose concrete, ensuring a solid base for the new repair material. Follow this by scrubbing the entire repair area with a wire brush to remove any remaining debris, dust, or weakened concrete, providing a rough surface for better adhesion. For larger voids where material might fall out, measure the area with a tape measure and cut wooden planks to create temporary forms using a circular saw. Secure these forms in place with a hammer and nails or screws to support the repair mixture.
Goal: Create a stable and clean base for concrete repair materials.
What's used
Tools
- Chisel
- Masonry chisel
- Circular Saw
- Jigsaw
- Hammer
- Nails or Screws
- Safety Glasses
- Tape Measure
- Wire Brush
- Wooden Planks
- Melamine boards
About the full video
This DIY project demonstrates how to repair damaged concrete stairs by patching chips and cracks with a quick-setting cement mix, then applying a concrete resurfacer to create a uniform, refreshed, and safer walking surface. The process involves preparing the old concrete, mixing and applying repair materials, and finally resurfacing all exposed concrete areas for a cohesive new look.
Step 2 of 6: Undercut Edges for Better Adhesion
Using a cold chisel and a hammer, carefully chip away at the edges of the damaged concrete. The goal is to create a slightly wider opening at the base than at the surface. This 'undercutting' technique ensures that the repair material has more surface area to bond to and creates a stronger, more durable repair that is less likely to pop out.
Every video in How to Fix a Crumbling Concrete Step Corner
Step 1: Clean the Damaged Area
- 1:36–3:50 Clean Out Loose Concrete and Debris
- 0:58–1:49 Clean Surface with Wire Brush and Broom
- 0:33–1:10 Prepare Damaged Concrete Surface
Step 2: Undercut Edges for Better Adhesion
- 0:30–0:45 Prepare Damaged Area
- 0:43–1:02 Prepare Damaged Concrete and Install Forms (this video)
- 0:27–0:56 Remove Unsound Concrete
Step 3: Mix Concrete Repair Material
- 3:49–4:29 Mix the Fast-Setting Repair Mortar
- 0:32–0:40 Mix Concrete Repair Material
- 1:32–2:17 Mix the Quick-Setting Cement
Step 4: Apply Concrete Repair Material
- 0:49–1:16 Fill and Shape with Patching Cement
- 3:43–4:30 Apply and Smooth Cement
- 2:32–3:19 Apply and Rough Shape Cement
Step 5: Shape and Finish the Repair
- 1:16–1:29 Finish and Blend the Surface
- 7:09–8:52 Shape and Finish the Mortar
- 3:19–4:06 Finish with Sponge Float
Step 6: Cure the Repaired Area
- 5:21–5:39 Water Cure Repaired Concrete Steps
- 2:52–3:01 Cure the Repaired Concrete
- 2:32–2:45 Cure Cementitious Repairs
How to Fix a Crumbling Concrete Step Corner
This project outlines the steps to repair a crumbling concrete step corner, involving cleaning, repairing, and resurfacing the damaged area to restore its structural integrity and appearance.
Read the full guide Browse all guides
Planning this project? Shop Oak Valley Designs.

