Finish with Sponge Float
From How to Fix a Crumbling Concrete Step Corner · Step 5 of 6 · Video by Kirk Giordano plastering Inc.

Showing 3:19–4:06 of the source video. Watch the full video with every moment.
What happens in this clip
Once the cement has been applied and roughly shaped, use a sponge float to smooth and finish the surface. Gently rub the sponge float over the new cement in circular motions or long, even strokes to create a uniform texture that blends seamlessly with the surrounding, older concrete. The presenter notes that for fine cracks, polyurethane caulk or silicone might be a better choice as cement in fine cracks tends to re-crack, but for larger patches, this method is effective.
Goal: Achieve a smooth, finished surface that matches the surrounding concrete.
What's used
Tools
- Sponge float
- Hand trowel (for a very smooth finish)
About the full video
This project demonstrates a quick and effective method to repair cracked and crumbling concrete on steps or pathways. The process involves removing loose and damaged concrete, thoroughly cleaning the repair area, mixing fresh cement with an accelerating additive to speed up curing, and applying it to reshape the damaged section, finishing with a sponge float for a smooth and blended appearance.
Step 5 of 6: Shape and Finish the Repair
As the repair material begins to set, use a finishing trowel to strike off any excess material and to create a smooth, level surface that matches the surrounding concrete. Pay close attention to the edges and corners to create a seamless appearance. If necessary, use a damp sponge or a concrete float to further refine the texture and achieve a consistent finish. The goal is to make the repair as invisible as possible.
Every video in How to Fix a Crumbling Concrete Step Corner
Step 1: Clean the Damaged Area
- 1:36–3:50 Clean Out Loose Concrete and Debris
- 0:58–1:49 Clean Surface with Wire Brush and Broom
- 0:33–1:10 Prepare Damaged Concrete Surface
Step 2: Undercut Edges for Better Adhesion
- 0:30–0:45 Prepare Damaged Area
- 0:43–1:02 Prepare Damaged Concrete and Install Forms
- 0:27–0:56 Remove Unsound Concrete
Step 3: Mix Concrete Repair Material
- 3:49–4:29 Mix the Fast-Setting Repair Mortar
- 0:32–0:40 Mix Concrete Repair Material
- 1:32–2:17 Mix the Quick-Setting Cement
Step 4: Apply Concrete Repair Material
- 0:49–1:16 Fill and Shape with Patching Cement
- 3:43–4:30 Apply and Smooth Cement
- 2:32–3:19 Apply and Rough Shape Cement
Step 5: Shape and Finish the Repair
- 1:16–1:29 Finish and Blend the Surface
- 7:09–8:52 Shape and Finish the Mortar
- 3:19–4:06 Finish with Sponge Float (this video)
Step 6: Cure the Repaired Area
- 5:21–5:39 Water Cure Repaired Concrete Steps
- 2:52–3:01 Cure the Repaired Concrete
- 2:32–2:45 Cure Cementitious Repairs
How to Fix a Crumbling Concrete Step Corner
This project outlines the steps to repair a crumbling concrete step corner, involving cleaning, repairing, and resurfacing the damaged area to restore its structural integrity and appearance.
Read the full guide Browse all guides
Planning this project? Shop Oak Valley Designs.

