Mark Initial Stair Profile
From How to Scribe and Cut a Stair Skirt Board to Fit · Step 2 of 5 · Video by Hard Work

Showing 0:03–0:07 of the source video. Watch the full video with every moment.
What happens in this clip
Begin by positioning a piece of baseboard trim against the wall at the base of the stair. Using a black marker, draw a horizontal line on the baseboard to indicate the top edge of the stair tread. Next, move the baseboard and place it vertically against the wall where the stair riser meets the floor. Draw a vertical line on the baseboard, extending downwards from the previously marked horizontal line, to define the point where the baseboard will meet the floor at the bottom of the riser. These two lines establish the initial profile of the stair step on the baseboard.
Goal: Define the basic outline of the stair step on the baseboard.
What's used
Tools
- Baseboard Trim
- Marker (Black)
- Fine-tip felt pen
About the full video
This project provides step-by-step instructions on how to precisely cut and fit baseboard trim to create a seamless, professional finish around stair steps. It emphasizes accurate measuring and marking techniques using common tools to achieve a polished, integrated look.
Step 2 of 5: Transfer Stair Profile to Skirt Board
Hold a long framing square or a specialized stair scribing tool against the wall and the first riser. Align one edge of the square with the wall and the other with the riser. Slide the square down until its corner meets the pencil mark for the riser height. Use a pencil to trace the profile of the stair onto the skirt board material. Repeat this process for each stair tread and riser.
Every video in How to Scribe and Cut a Stair Skirt Board to Fit
Step 1: Measure and Mark Riser Heights
- 0:00–0:26 Understand Stair Dimensions
- 7:29–11:09 Measure and Determine Cut Angles
- 4:48–7:28 Layout Straight Skirt Board
Step 2: Transfer Stair Profile to Skirt Board
- 0:26–1:49 Layout Skirt Board Profile
- 5:39–9:34 Mark Riser and Tread Cut Lines Using a Jig
- 0:03–0:07 Mark Initial Stair Profile (this video)
Step 3: Cut the Skirt Board
- 1:15–2:34 Trace and Cut Skirt Boards
- 2:44–4:14 Cut and Install the Skirt Board
- 19:55–24:58 Cut and Sand Skirt Board
Step 4: Dry Fit and Adjust
- 2:14–2:33 Test Fit and Adjust Skirt Board (Method 1)
- 11:24–12:39 Test Fit the Straight Skirt Board
- 25:53–26:23 Test Fit the "Open" Skirt Board
Step 5: Install the Skirt Board
- 1:58–2:58 Secure Skirtboard
- 13:28–15:24 Install Skirt Boards
- 3:40–4:14 Install Skirt Boards
How to Scribe and Cut a Stair Skirt Board to Fit
Outline for scribing and cutting a stair skirt board to achieve a snug fit against the wall and risers.
Read the full guide Browse all guides
Planning this project? Shop Oak Valley Designs.

