Assess Damage & Prepare for Repair
From How to Check Stairs for Rot or Damage Before Covering Them · Step 2 of 5 · Video by gregvancom

Showing 0:00–0:53 of the source video. Watch the full video with every moment.
What happens in this clip
Begin by thoroughly inspecting the exterior stair structure. Identify any treads or risers that are loose, cracked, splintered, or show signs of rot. Note how the treads and risers are currently attached to the stringers (e.g., using wedges, nails, or other fasteners). The video highlights that original wedges often loosen, fall out, or become damaged, leading to instability. Determine if a full tread replacement is necessary, or if reinforcement of existing, salvable treads/risers is sufficient.
Goal: Examine the existing stair structure to identify loose, rotted, or damaged treads, risers, and stringers. Understand the current fastening method and prepare the area for replacement or reinforcement.
What's used
Tools
- Pry Bar
- Safety Gloves
About the full video
This guide provides various methods for repairing and reinforcing exterior stair treads, focusing on replacing damaged components with durable pressure-treated lumber. It covers techniques for reinforcing tread and riser connections, adding structural support, and using threaded rods to tighten the entire assembly, ensuring longevity and resistance to moisture and decay.
Step 2 of 5: Probe for Soft Spots and Rot
After the visual inspection, systematically probe the surfaces of the treads, risers, and the visible portions of the stringers. Insert the tip of a sturdy screwdriver or an awl into the wood and apply moderate pressure. Move the probe in short increments. Listen for any unusual sounds like crunching or squishing, which can signal decay. Feel for any areas that feel soft, spongy, or give way easily under pressure. If the probe penetrates the wood with little resistance, it's a strong indication of rot or significant damage. Pay special attention to areas near the nosing of the treads and where the stringers meet the treads.
Every video in How to Check Stairs for Rot or Damage Before Covering Them
Step 1: Inspect Treads and Risers for Surface Damage
- 0:00–0:53 Assess Damage & Prepare for Repair
- 1:02–1:35 Visually Inspect for Staircase Wear and Damage
Step 2: Probe for Soft Spots and Rot
- 3:55–4:18 Inspect for Rot and Soft Spots
- 0:35–0:51 Test Suspected Decayed Areas
- 0:00–0:53 Assess Damage & Prepare for Repair (this video)
Step 3: Check Stringer Integrity
- 3:26–4:07 Prioritize Maintenance and Safety
- 0:54–1:40 Identify Stringer Cracks
- 0:05–0:14 Identify and Assess Damage
Step 4: Assess Fastener Security
- 0:00–0:53 Assess Damage & Prepare for Repair
- 3:26–4:07 Prioritize Maintenance and Safety
- 0:12–0:14 Final Test and Inspection
Step 5: Test for Stability and Squeaks
- 0:12–0:14 Final Test and Inspection
- 4:28–5:00 Test the Repaired Stairs
- 3:29–3:39 Eliminate Squeaks from Treads
How to Check Stairs for Rot or Damage Before Covering Them
A high-level outline for a DIY project to inspect stairs for rot or damage before covering them. This involves visual inspection, probing for softness, checking for structural integrity, and assessing the condition of treads, risers, and stringers.
Read the full guide Browse all guides
Planning this project? Shop Oak Valley Designs.

