Trim Ladder Legs to Proper Length
From How to Trim Attic Ladder Legs to the Right Length · Step 2 of 4 · Video by VideoJoeKnows

Showing 11:00–13:10 of the source video. Watch the full video with every moment.
What happens in this clip
After the ladder assembly is fully installed in the ceiling, the next step is to adjust the length of the ladder's legs to properly reach the floor. The presenter explains that the ladder needs to be trimmed because, as installed, it extends too far and doesn't sit correctly. He points out that the bottom portion of the aluminum ladder needs to be cut off, emphasizing that trial and error might be necessary, suggesting to cut small increments (e.g., 1 inch, then ¾ inch) from both legs evenly until the ladder sits perfectly on the floor. He demonstrates how to extend the ladder fully and identifies the section that needs trimming.
Goal: Adjust the length of the ladder legs to reach the floor correctly
What's used
Tools
- Hacksaw
- Marking Pencil/Marker
- Sawhorses (optional)
- Tape Measure
About the full video
This video provides detailed instructions on how to install a pre-assembled attic ladder, focusing on the challenging process of lifting the entire unit into a high ceiling opening, temporarily securing it, making precise adjustments for squareness, and finally trimming the ladder legs to the correct length. It emphasizes the need for an assistant and proper tools for a successful installation.
Step 2 of 4: Mark Cutting Lines on Ladder Legs
Extend the attic ladder fully. Using your measured length from Step 1, mark a clear cutting line on each of the attic ladder legs. Ensure the marks are perpendicular to the length of the leg for a clean cut. You will be cutting the legs to shorten them.
Every video in How to Trim Attic Ladder Legs to the Right Length
Step 1: Measure Ladder Leg Length
- 0:00–0:36 Assess and Measure Required Cut Length
- 7:46–8:35 Trim the Ladder to Length
- 0:21–1:52 Measure the Attic Opening and Ceiling Height
Step 2: Mark Cutting Lines on Ladder Legs
- 10:35–12:30 Trim Ladder Legs to Length
- 11:00–13:10 Trim Ladder Legs to Proper Length (this video)
- 6:26–7:41 Adjust and Cut Ladder Length
Step 3: Cut Attic Ladder Legs
- 6:06–6:39 Cut the Ladder Feet
- 10:35–12:30 Trim Ladder Legs to Length
- 0:48–0:54 Cut and Reattach Second Ladder Leg
Step 4: Test Fit the Ladder Legs
- 4:28–5:38 Final Adjustments and Ladder Sizing
- 6:06–6:39 Cut the Ladder Feet
- 0:48–0:54 Cut and Reattach Second Ladder Leg
How to Trim Attic Ladder Legs to the Right Length
This project outlines the process of trimming attic ladder legs to ensure a proper fit and secure installation. It involves measuring, marking, cutting, and testing the ladder legs for the correct length.
Read the full guide Browse all guides
Planning this project? Shop Oak Valley Designs.

