powered by

How to install an attic ladder...Part 6

Video by VideoJoeKnows · 1 moment used in Oak Valley Designs's DIY guides · 16:28 long

Moments in this video

  1. 11:00–13:10 Trim Ladder Legs to Proper Length From How to Trim Attic Ladder Legs to the Right Length, Step 2: Mark Cutting Lines on Ladder Legs

    After the ladder assembly is fully installed in the ceiling, the next step is to adjust the length of the ladder's legs to properly reach the floor. The presenter explains that the ladder needs to be trimmed because, as installed, it extends too far and doesn't sit correctly. He points out that the bottom portion of the aluminum ladder needs to be cut off, emphasizing that trial and error might be necessary, suggesting to cut small increments (e.g., 1 inch, then ¾ inch) from both legs evenly until the ladder sits perfectly on the floor. He demonstrates how to extend the ladder fully and identifies the section that needs trimming.

The guide that use this video

More from the Oak Valley Designs DIY Hub

Read the guide Browse all guides

Planning this project? Shop Oak Valley Designs.

How to install an attic ladder...Part 6 — step-by-step moments | Oak Valley Designs

Subscribe for exclusive updates

Be the first to know about promotions, new products, and sales.