Final Adjustments and Ladder Sizing
From How to Trim Attic Ladder Legs to the Right Length · Step 4 of 4 · Video by Lowe's Home Improvement

Showing 4:28–5:38 of the source video. Watch the full video with every moment.
What happens in this clip
After the frame is securely in place, test the operation of the attic ladder by pulling it down and folding it back up to ensure it moves smoothly. Once satisfied, remove the temporary support boards and trim any shims that were used. The ladder legs are adjustable, so measure the distance from the floor to the bottom edge of the attic stair frame (opposite the hinge side). Consult your attic stair's manual to determine how much to cut off the ladder legs based on this measurement. Finally, cut the tie holding the ladder segments together, unfold the ladder completely, and use a hacksaw to cut the legs to the correct size. Attach the adjustable feet to the cut ends of the ladder legs, pressing them down firmly to ensure they sit squarely on the floor. Pre-drill and bolt the feet in place.
Goal: Ensure the ladder operates smoothly and is the correct length.
What's used
Tools
- Adjustable Ladder Feet
- Attic Stair Manual
- Bolts/Hardware for Feet
- Drill Craftsman
- Hacksaw
- Pencil
- Tape Measure
- Utility Knife
About the full video
This project guides you through the process of installing a new attic stair system, from planning the location and framing the opening to installing the ladder unit and adding decorative trim. It covers how to safely cut ceiling joists, brace the structure, install the ladder, and adjust its length for proper fit and function.
Step 4 of 4: Test Fit the Ladder Legs
Carefully place the attic ladder back into its installed position in the attic opening. Check that the legs now fit the measured height correctly and that the ladder sits level and stable on the floor. Make any minor adjustments if needed.
Every video in How to Trim Attic Ladder Legs to the Right Length
Step 1: Measure Ladder Leg Length
- 0:00–0:36 Assess and Measure Required Cut Length
- 7:46–8:35 Trim the Ladder to Length
- 0:21–1:52 Measure the Attic Opening and Ceiling Height
Step 2: Mark Cutting Lines on Ladder Legs
- 10:35–12:30 Trim Ladder Legs to Length
- 11:00–13:10 Trim Ladder Legs to Proper Length
- 6:26–7:41 Adjust and Cut Ladder Length
Step 3: Cut Attic Ladder Legs
- 6:06–6:39 Cut the Ladder Feet
- 10:35–12:30 Trim Ladder Legs to Length
- 0:48–0:54 Cut and Reattach Second Ladder Leg
Step 4: Test Fit the Ladder Legs
- 4:28–5:38 Final Adjustments and Ladder Sizing (this video)
- 6:06–6:39 Cut the Ladder Feet
- 0:48–0:54 Cut and Reattach Second Ladder Leg
How to Trim Attic Ladder Legs to the Right Length
This project outlines the process of trimming attic ladder legs to ensure a proper fit and secure installation. It involves measuring, marking, cutting, and testing the ladder legs for the correct length.
Read the full guide Browse all guides
Planning this project? Shop Oak Valley Designs.

