Reinforce Risers and Treads with Adhesive and Timber
From How to Stop a Stair Tread from Creaking and Shifting · Step 3 of 5 · Video by Ultimate Handyman

Showing 2:05–4:08 of the source video. Watch the full video with every moment.
What happens in this clip
Begin by applying the 'Lumberjack Wood Adhesive Professional Grade' into any existing gaps where the stair treads meet the risers from underneath. Use the sealant gun to inject a generous amount of adhesive, ensuring it fills the voids. This adhesive expands slightly, helping to fill irregular gaps and create a tight bond. After applying adhesive to the new timber piece, position it flush against the riser-tread joint and immediately screw it in place using the cordless drill and 'Turbo Gold Screws.' The video demonstrates using four screws through the new timber into the riser and three screws upwards into the tread, ensuring a strong, secure connection.
Goal: Securely brace the stair risers and treads to prevent movement and squeaking.
What's used
Tools
- Cordless Drill DeWalt
- Impact driver
- Protective Gloves
- Nitrile gloves
- Safety Glasses
- Sealant Gun
Materials
- Lumberjack Wood Adhesive Professional Grade Lumberjack
- Polyurethane wood glue
- Timber Pieces
- Hardwood lumber
- Turbo Gold Screws Turbo Gold
- Decking screws
About the full video
This project demonstrates a method to eliminate squeaky stairs by reinforcing the treads and risers from underneath. The process involves removing any existing inadequate braces, applying an expanding wood adhesive into gaps, and then screwing solid timber pieces to securely connect the risers and treads, thereby stopping movement and noise.
Step 3 of 5: Address Gaps with Shims and Adhesive
If there are visible gaps between the tread and the riser, or between the tread and the stringer, apply a wood adhesive into the gap. Then, carefully insert thin wood shims into the gap, tapping them gently until they are snug. The goal is to eliminate any play or movement. Trim any excess shim material flush with the tread surface once it's secure.
Every video in How to Stop a Stair Tread from Creaking and Shifting
Step 1: Inspect the Stair Tread
- 2:21–3:48 Diagnose Creaking Causes
Step 2: Secure Loose Tread Edges
- 6:29–7:31 Drive Screws to Secure Tread to Riser
- 6:13–6:27 Secure Front Treads with Screws
- 5:17–6:11 Fasten New Treads with Screws
Step 3: Address Gaps with Shims and Adhesive
- 6:22–6:49 Apply 5-Minute Wood Adhesive
- 6:40–7:13 Apply Wood Glue (Back Risers)
- 2:05–4:08 Reinforce Risers and Treads with Adhesive and Timber (this video)
Step 4: Reinforce with Stair Tread Repair Brackets
- 4:51–8:26 Fix with Heavy-Duty Stair Angle Brackets (Method 2)
- 0:15–2:32 Fix with A35 Brackets (Method 1)
- 0:33–0:58 Utilize Prefabricated Metal Brackets
Step 5: Fill Screw Holes and Finish
- 0:22–0:30 Fill Screw Holes with Wood Putty
- 1:40–2:44 Prepare Surface by Filling Holes
- 4:25–4:47 Fill Gaps and Nail Holes
How to Stop a Stair Tread from Creaking and Shifting
Outline for a DIY project to fix a creaking and shifting stair tread.
Read the full guide Browse all guides
Planning this project? Shop Oak Valley Designs.

