Apply Wood Glue (Back Risers)
From How to Stop a Stair Tread from Creaking and Shifting · Step 3 of 5 · Video by Fix it with Fowler

Showing 6:40–7:13 of the source video. Watch the full video with every moment.
What happens in this clip
Before adding mechanical fasteners to the back risers, apply a generous bead of wood glue along the entire seam where the top of each riser meets the underside of the tread above it. The goal is for the glue to seep into any gaps and expand slightly as it dries, creating a strong bond and further eliminating movement. Allow the glue a few minutes to settle before proceeding with drilling.
Goal: Apply a bead of wood glue along the back edge of each riser where it meets the tread above to provide additional bonding and reduce movement.
What's used
Materials
- Wood Glue (e.g.
- Evo-Stik Wood Glue)
About the full video
This project provides detailed instructions on how to eliminate squeaks and creaks from old wooden stairs by securing loose treads and risers using screws and wood glue. The process involves removing existing carpet and gripper rods, marking and drilling pilot holes for new fasteners, applying wood glue, and then re-installing the carpet and underlay.
Step 3 of 5: Address Gaps with Shims and Adhesive
If there are visible gaps between the tread and the riser, or between the tread and the stringer, apply a wood adhesive into the gap. Then, carefully insert thin wood shims into the gap, tapping them gently until they are snug. The goal is to eliminate any play or movement. Trim any excess shim material flush with the tread surface once it's secure.
Every video in How to Stop a Stair Tread from Creaking and Shifting
Step 1: Inspect the Stair Tread
- 2:21–3:48 Diagnose Creaking Causes
Step 2: Secure Loose Tread Edges
- 6:29–7:31 Drive Screws to Secure Tread to Riser
- 6:13–6:27 Secure Front Treads with Screws
- 5:17–6:11 Fasten New Treads with Screws
Step 3: Address Gaps with Shims and Adhesive
- 6:22–6:49 Apply 5-Minute Wood Adhesive
- 6:40–7:13 Apply Wood Glue (Back Risers) (this video)
- 2:05–4:08 Reinforce Risers and Treads with Adhesive and Timber
Step 4: Reinforce with Stair Tread Repair Brackets
- 4:51–8:26 Fix with Heavy-Duty Stair Angle Brackets (Method 2)
- 0:15–2:32 Fix with A35 Brackets (Method 1)
- 0:33–0:58 Utilize Prefabricated Metal Brackets
Step 5: Fill Screw Holes and Finish
- 0:22–0:30 Fill Screw Holes with Wood Putty
- 1:40–2:44 Prepare Surface by Filling Holes
- 4:25–4:47 Fill Gaps and Nail Holes
How to Stop a Stair Tread from Creaking and Shifting
Outline for a DIY project to fix a creaking and shifting stair tread.
Read the full guide Browse all guides
Planning this project? Shop Oak Valley Designs.

