Lay Out and Cut the First Stringer
From How to Measure Deck Stair Stringer Length · Step 6 of 6 · Video by decks.com

Showing 0:57–1:08 of the source video. Watch the full video with every moment.
What happens in this clip
Obtain a 2x12 piece of lumber for the stringer. Using a framing square, carefully transfer the calculated rise and run dimensions onto the 2x12, marking all cut lines with a pencil. After marking, use a circular saw to meticulously cut along these lines to create the first stringer. This initial stringer is critical as it will serve as a template; use it to accurately trace and cut all subsequent stringers, ensuring consistency across the entire staircase.
Goal: Accurately cut the first stringer to serve as a template for all others.
What's used
Tools
- 2x12 Lumber
- Circular Saw
- but less efficient for long straight lines)
- Framing Square
- Pencil
About the full video
This project provides a comprehensive, step-by-step guide to constructing and installing deck stairs. It covers initial measurements, calculating rise and run for stringers, cutting the stringers, two methods for attaching stringers to the deck frame, and finally, installing the decking boards for treads and risers.
Step 6 of 6: Mark Stringer Lumber
Take your chosen lumber (typically a 2x10 or 2x12) and use your tape measure and pencil to mark the calculated diagonal stringer length from one end. Ensure the mark is accurate and perpendicular to the edge of the board for a clean cut.
Every video in How to Measure Deck Stair Stringer Length
Step 1: Measure Total Rise
- 0:17–0:31 Measure Total Rise
- 0:34–1:02 Determine Total Rise
- 0:09–0:18 Measure Total Stair Height
Step 2: Determine Riser Height
- 1:02–2:45 Calculate Riser Dimensions
- 0:51–1:37 Calculate Individual Step Rise and Total Run
- 4:32–5:10 Calculate Individual Riser Height
Step 3: Calculate Number of Treads
- 0:54–1:13 Determine Number of Treads
- 3:54–5:04 Calculate the Number of Treads and Understand the Logic
- 2:59–6:51 Calculate Number of Risers and Treads
Step 4: Determine Run Per Tread
- 1:13–1:29 Calculate Total Run
- 1:31–2:57 Calculate Unit Run and Total Run
- 10:55–11:31 Calculate Overall Run (Treads)
Step 5: Calculate Diagonal Stringer Length
Step 6: Mark Stringer Lumber
- 6:12–7:01 Marking the Stringers
- 0:57–1:08 Lay Out and Cut the First Stringer (this video)
- 1:41–2:21 Mark Stringer Notches
How to Measure Deck Stair Stringer Length
This project outlines the process of accurately measuring and calculating the required length for deck stair stringers. It involves determining the total rise, the run of each step, and accounting for the angle of the stairs to ensure a safe and consistent tread depth and riser height. The final measurement will be used to mark and cut the stringers from lumber.
Read the full guide Browse all guides
Planning this project? Shop Oak Valley Designs.

