Fit Skirting Board to Wall
From Stair Skirt Boards and Trim Refresher · Step 7 of 10 · Video by Skirting4U
Showing 0:23–0:26 of the source video.
What happens in this clip
Carefully position the adhesive-backed skirting board against the wall. Press it firmly into place, ensuring it sits flush against both the floor and the wall. Pay close attention to aligning any mitered joints with adjacent skirting board pieces to create a seamless corner. Hold it in place for a moment to allow the adhesive to begin gripping.
Goal: Attach the skirting board to the wall with adhesive, ensuring proper alignment.
What's used
Tools
- Skirting Board (with adhesive applied)
About the full video
This project provides step-by-step instructions for fitting a skirting board using basic DIY tools, covering measuring, precise cutting, adhesive application, secure nailing with pilot holes, and finishing with caulk.
Step 7 of 10: Install New Trim (Base Shoe/Quarter-Round)
Measure and cut your chosen trim (e.g., base shoe or quarter-round) to fit the length of the skirt board. Apply a small amount of construction adhesive to the back of the trim. Press the trim into place along the bottom edge of the skirt board and against the floor. Secure it with finish nails, ensuring they are placed at an angle to go into the skirt board and not the floor sub-straight if possible. Drive nails just below the surface.
Other videos for this step
Stair Skirt Boards and Trim Refresher
This project involves removing old stair skirt boards and trim, preparing the wall and stairs, and installing new skirt boards and trim for a refreshed look. It includes measuring, cutting, fitting, fastening, and finishing the new trim pieces.
Read the full guide Browse all guides
Planning this project? Shop Oak Valley Designs.