Final Trimming and Inspection

What happens in this clip

After all carpet sections have been laid and secured, perform a final inspection of the entire staircase. Use your utility knife to meticulously trim any remaining excess carpet, especially where the stairs meet the baseboards, walls, or the top landing. Ensure all carpet edges are perfectly flush and clean. Press down on all carpet surfaces to check for any loose spots or areas where the adhesive may not have fully bonded, and re-staple if necessary. The goal is a seamless, tight, and professional-looking carpet installation.

Goal: Achieve a polished, secure, and completed carpeted staircase

What's used

Tools

• Staple Gun
• Utility Knife

Materials

• Carpet (installed)
• Staples

About the full video

This project provides a detailed guide on how to install carpet on wooden stairs, covering essential steps from precise measurement and carpet cutting to adhesive application, careful laying, and securing the carpet with staples and trimming for a professional finish. It demonstrates techniques for handling various stair shapes and ensuring a durable and aesthetically pleasing result.

Step 8 of 8: Inspect and Clean Up

Walk up and down the stairs, pressing on each tread to ensure it is firmly attached and there are no loose edges or signs of lifting. Check that all treads are aligned properly and present a consistent look. Remove any tools, excess materials, or adhesive residue from the stairs and surrounding areas. Vacuum the stairs to remove any stray carpet fibers or dust.

Open this step in the guide

Every video in How to Install Carpet Stair Treads on Curved Stairs

1. Step 1: Measure Tread Dimensions

   • 0:00–0:03 Measure Individual Stair Components
   • 0:12–0:57 Measure and Cut Carpet Tread
   • 0:29–1:33 Prepare Stairs and Measure Grippers

2. Step 2: Create a Template for Each Tread

   • 1:15–3:04 Create Template for First Winder Step
   • 0:59–1:36 Creating Custom Templates for Each Step
   • 4:33–5:37 Create Template for Second Winder Step

3. Step 3: Cut Carpet Treads from Templates

   • 8:08–9:23 Cut Carpet Pieces
   • 6:52–8:08 Transfer Templates to Carpet Backing
   • 2:09–3:19 Measure and Cut Carpet Pieces

4. Step 4: Prepare Stair Surface

   • 0:34–0:40 Clean the Stairs
   • 0:17–0:34 Prepare the Stairs
   • 0:00–0:05 Prepare Stairs and Treads

5. Step 5: Apply Adhesive

   • 0:05–0:06 Apply Adhesive to Treads
   • 0:04–0:08 Apply Spray Adhesive
   • 0:34–0:46 Apply Carpet Adhesive to Stairs

6. Step 6: Attach Carpet Tread to Stair

   • 0:11–0:43 Install Remaining Carpet Stair Treads
   • 0:04–0:06 Install Carpet Treads
   • 1:16–2:09 Install Carpet Treads with Adhesive

7. Step 7: Secure Edges and Trim

   • 3:53–7:38 Trim Excess Carpet and Prepare Final Riser
   • 2:25–3:45 Position and Secure Carpet Edges
   • 2:42–3:56 Secure the First Section with Staples

8. Step 8: Inspect and Clean Up

   • 3:59–4:29 Final Trimming and Inspection (this video)
   • 16:47–18:07 Final Review and Cleanup
   • 0:46–0:57 Final Inspection and Cleanup