Remove Staples and Protruding Nails
From How to Remove Carpet Staples and Tack Strips from Stairs · Step 3 of 4 · Video by Ace Hardware

Showing 1:19–1:49 of the source video. Watch the full video with every moment.
What happens in this clip
After removing the pad and tack strips, there will likely be numerous staples left embedded in the wooden stairs. To find them, use a scraper or a dustpan to sweep across the surface of the steps; you'll hear or feel when you hit a staple. Use needle-nose pliers or a nail puller to grip and extract each staple. Some staples may be too flush or stubborn, so you might need to use a pry bar or a flathead screwdriver to gently pry them up from underneath before pulling them out. As you clean, you may also find a nail or two sticking up from the subfloor; use a hammer to pound these firmly back into the wood until they are flush or slightly countersunk.
Goal: Thoroughly remove all remaining staples and pound down any nails that are still sticking out from the subfloor.
What's used
Tools
- Dustpan
- Flathead Screwdriver
- Hammer
- Nail Puller
- Needle-Nose Pliers
- Pry Bar
- Scraper
About the full video
This video provides a detailed guide on how to remove old carpeting, carpet padding, tack strips, staples, and any protruding nails from a wooden staircase. It covers the entire demolition and initial cleanup process to prepare the stairs for a new flooring installation.
Step 3 of 4: Remove Old Adhesive and Debris
After removing staples and tack strips, inspect the stairs for any leftover adhesive or carpet backing. Use a stiff putty knife or a specialized floor scraper to chip away and scrape off these residues. Hold the scraper at a low angle to avoid digging into the wood. Work across the entire surface of each tread and riser.
Every video in How to Remove Carpet Staples and Tack Strips from Stairs
Step 1: Remove Carpet Staples
- 1:19–1:49 Remove Staples and Protruding Nails
- 4:20–5:27 Extract Staples from Treads and Risers
- 0:31–0:55 Remove Tack Strips and Staples
Step 2: Remove Tack Strips
- 1:02–1:12 Remove Tack Strips
- 3:58–4:58 Remove Tack Strips
- 5:27–7:10 Remove Tack Strips
Step 3: Remove Old Adhesive and Debris
- 1:02–1:07 Scrape off Adhesive Residue
- 0:31–0:35 Remove Staples and Glue Residue
- 1:19–1:49 Remove Staples and Protruding Nails (this video)
Step 4: Clean the Stair Surface
- 3:30–4:06 Vacuuming Staircase Debris
- 0:23–0:26 Clean and Prepare Stairs for Finishing
- 2:50–3:34 Final Clean Up
How to Remove Carpet Staples and Tack Strips from Stairs
This project involves safely removing carpet staples and tack strips from stairs to prepare the surface for a new flooring material or for refinishing. It requires careful attention to detail to avoid damaging the underlying stairs.
Read the full guide Browse all guides
Planning this project? Shop Oak Valley Designs.

