Measure Winder Steps Depth
From How to Install Carpet Treads on Winder Steps · Step 2 of 4 · Video by The Home Improvements Channel UK

Showing 4:47–7:15 of the source video. Watch the full video with every moment.
What happens in this clip
Winder steps are angled or pie-shaped, and measuring them requires careful attention to the pile direction. The pile should always run square to the face of the riser. Use a straight edge (like a small saw as demonstrated in the video) to visualize the 'square' cut needed. Measure the depth of each winder step from its furthest back corner, straight down the riser, and across the deepest part of the tread. For all winder steps (W1, W2, W3), record the deepest measurement, and add extra (e.g., 6 inches) for tucking and trimming.
Goal: Measure the depth of each winder step from the back corner to the front edge, ensuring to follow the pile direction principle.
What's used
Tools
- Notebook/Paper
- Pencil
- Small Saw or Straight Edge
- Tape Measure
About the full video
This video provides detailed instructions on how to measure winder stairs (angled or pie-shaped steps) for carpet installation, considering pile direction and allowing for extra material during cuts. It covers measuring top landings, straight stairs, winder steps, and half landings, culminating in creating a custom carpet plan based on these precise measurements.
Step 2 of 4: Measure and Mark for Winder Tread Cuts
Winder stairs have angled treads that meet at a corner, requiring custom cuts for carpet treads. For each winder tread, measure its depth from the nosing to the back of the tread at the narrowest point and the widest point. Then, measure the width of the tread at the nosing and at the back. Carefully mark these dimensions onto the carpet tread material, paying close attention to the angle of the winder. A common method is to trace the shape of the existing tread onto the back of the carpet tread material, ensuring the pattern or pile direction is consistent across all treads.
Every video in How to Install Carpet Treads on Winder Steps
Step 1: Inspect and Prepare Existing Treads
- 0:34–0:40 Clean the Stairs
- 0:09–0:45 Prepare and Clean Stair Treads
- 0:00–0:01 Prepare and Measure Stairs
Step 2: Measure and Mark for Winder Tread Cuts
- 4:47–7:15 Measure Winder Steps Depth (this video)
- 7:20–9:07 Measure and Cut Carpet
- 7:25–8:46 Measure Winder Steps Width
Step 3: Cut Carpet Treads for Winder Stairs
- 8:08–9:23 Cut Carpet Pieces
- 0:12–0:57 Measure and Cut Carpet Tread
- 2:15–3:58 Cut and Secure Second Angled Tread
Step 4: Attach Carpet Treads to Winder Stairs
- 1:16–2:09 Install Carpet Treads with Adhesive
- 0:04–0:06 Install Carpet Treads
- 10:14–11:57 Install Carpet on First Winder Step
How to Install Carpet Treads on Winder Steps
A high-level outline for installing carpet treads on winder steps, focusing on preparation, measurement, cutting, and attachment.
Read the full guide Browse all guides
Planning this project? Shop Oak Valley Designs.

