powered by

Install Carpet on First Winder Step

From How to Install Carpet Treads on Winder Steps · Step 4 of 4 · Video by Direct Carpet

Showing 10:14–11:57 of the source video. Watch the full video with every moment.

What happens in this clip

Begin by placing the first cut carpet piece onto the corresponding winder step. Ensure it's centered and aligned according to your earlier measurements. The carpet should extend past the nosing and sides, covering the tack strips. Use an electric stapler to secure the carpet along the back edge of the tread, just inside the tack strip. For the nosing, push the carpet down and around the edge, using the stapler to secure it underneath. The presenter emphasizes wiggling the stapler gun as you staple to help hide the staple marks within the carpet pile. The extra material can be trimmed if excessive, but often it's left for tucking. On the sides of the winder steps, the carpet will need to be carefully trimmed and tucked into the side edges using a utility knife and a carpet tucker to achieve a clean, seamless look.

What's used

Tools

  • Carpet Knee Kicker
  • Carpet Piece
  • Carpet Tucker
  • Electric Stapler Black & Decker
  • Utility Knife

About the full video

This project provides verbose, step-by-step instructions on how to accurately create paper templates for winder stairs, transfer those templates to carpet material, cut the carpet pieces, and then securely install the carpet runner using tack strips and staples. It emphasizes precision in measuring and cutting for a neat and safe finish on complex stair designs.

Step 4 of 4: Attach Carpet Treads to Winder Stairs

Once the carpet treads are cut and the existing treads are clean, it's time for attachment. Most carpet treads come with an adhesive backing or are designed to be attached with a strong, double-sided carpet tape or adhesive. Peel off the protective backing from the adhesive. Carefully align the carpet tread with the existing stair tread, starting from the back or the tightest angle of the winder. Press down firmly, working from the center outwards, to ensure complete contact and a secure bond. Pay special attention to the edges and corners of the winder treads to eliminate any lifting or gaps. For enhanced security, some carpet treads can be further secured with small staples or brads, though this is less common with pre-made treads and may damage the underlying tread.

Open this step in the guide

Every video in How to Install Carpet Treads on Winder Steps

  1. Step 1: Inspect and Prepare Existing Treads

  2. Step 2: Measure and Mark for Winder Tread Cuts

  3. Step 3: Cut Carpet Treads for Winder Stairs

  4. Step 4: Attach Carpet Treads to Winder Stairs

How to Install Carpet Treads on Winder Steps

A high-level outline for installing carpet treads on winder steps, focusing on preparation, measurement, cutting, and attachment.

Read the full guide Browse all guides

Planning this project? Shop Oak Valley Designs.

Install Carpet on First Winder Step — How to Install Carpet Treads on Winder Steps | Oak Valley Designs

Subscribe for exclusive updates

Be the first to know about promotions, new products, and sales.