Initial Tread Application

What happens in this clip

To begin applying the tread, first wash your hands thoroughly to remove any skin oils, which could affect the adhesive. Carefully peel back approximately 3 to 4 inches (7.6 to 10.2 cm) of the backing paper from one end of the anti-slip tread. Create a fold in the peeled backing paper, being cautious not to touch the exposed adhesive. Line up the center mark or crease on the anti-slip tread with the pencil mark on the masking tape on the stair. Once aligned, carefully place down the peeled portion of the tread onto the stair. Using the provided roller, press down firmly on this initial section to secure it and begin removing any air bubbles.

Goal: Partially apply the anti-slip tread, ensuring proper alignment and initial adhesion.

What's used

Tools

• Anti-slip stair tread Slips Away
• Roller
• Squeegee

About the full video

This video provides step-by-step instructions on how to easily install anti-slip stair treads on hardwood stairs, covering essential preparation, precise measurement for alignment, and proper application techniques to ensure a secure and bubble-free finish.

Step 4 of 5: Install Anti-Slip Treads (Alternative)

If using pre-formed anti-slip stair treads (rather than strips), align each tread carefully with the front edge of a stair. Most treads have an adhesive backing; remove this protective layer and press the tread firmly onto the stair. Ensure the tread lies flat and covers the desired surface area for maximum safety. Some treads may require screws for extra security, especially in high-traffic areas.

Open this step in the guide

Every video in How to Make Hardwood Stairs Safe for an Older Dog

1. Step 1: Clean Stair Treads

   • 0:34–0:40 Clean the Stairs
   • 0:09–0:45 Prepare and Clean Stair Treads
   • 0:04–0:07 Clean the Staircase

2. Step 2: Measure and Cut Traction Strips

   • 0:02 Measure and Cut Anti-Slip Strip
   • 0:20–0:25 Measure and Cut Anti-Slip Tape
   • 0:05–0:12 Measure and Cut Grip Tape Strips

3. Step 3: Apply Anti-Slip Traction Strips

   • 0:02–0:06 Apply Anti-Slip Strip
   • 1:14–1:23 Apply Non-Skid Strips to Steps
   • 1:07–1:32 Initial Tread Application

4. Step 4: Install Anti-Slip Treads (Alternative)

   • 1:07–1:32 Initial Tread Application (this video)
   • 0:54–1:07 Prepare Anti-Slip Tread
   • 0:51–4:06 Apply Adhesive-Backed Anti-Slip Products

5. Step 5: Secure Edges and Corners

   • 0:28–0:49 Inserting and Securing Anti-Slip Strips
   • 0:51–4:06 Apply Adhesive-Backed Anti-Slip Products
   • 0:02–0:06 Apply Anti-Slip Strip