Apply Anti-Slip Strip

What happens in this clip

Carefully peel back a section of the protective backing from one end of a pre-cut anti-slip strip. Align the exposed adhesive side of the strip along the edge of the stair, ensuring it is straight and centered. Slowly press the exposed part of the strip onto the stair, working from one end to the other, while gradually peeling off the rest of the backing. Once the entire strip is in place, firmly press down along its entire length with your hands to ensure good adhesion and to remove any trapped air bubbles.

Goal: Secure the anti-slip strip firmly to the stair edge

What's used

Tools

• Hands
• Squeegee

Materials

• Anti-slip staircase guard strip

About the full video

This project demonstrates the simple process of installing anti-slip "staircase guards" to prevent slips and falls on stairs. It involves preparing the stair surface, applying self-adhesive strips to the edge of each step, and trimming them to fit, significantly enhancing stair safety.

Step 5 of 5: Secure Edges and Corners

Go over all installed traction strips or treads, paying close attention to the edges and corners. Use firm pressure with your hands, a roller, or the edge of a tool to press down any areas that may be lifting. This step is critical for preventing the material from peeling up over time and creating a tripping hazard. If any corners consistently lift, a small amount of appropriate adhesive might be considered, following manufacturer guidelines.

Open this step in the guide

Every video in How to Make Hardwood Stairs Safe for an Older Dog

1. Step 1: Clean Stair Treads

   • 0:34–0:40 Clean the Stairs
   • 0:09–0:45 Prepare and Clean Stair Treads
   • 0:04–0:07 Clean the Staircase

2. Step 2: Measure and Cut Traction Strips

   • 0:02 Measure and Cut Anti-Slip Strip
   • 0:20–0:25 Measure and Cut Anti-Slip Tape
   • 0:05–0:12 Measure and Cut Grip Tape Strips

3. Step 3: Apply Anti-Slip Traction Strips

   • 0:02–0:06 Apply Anti-Slip Strip
   • 1:14–1:23 Apply Non-Skid Strips to Steps
   • 1:07–1:32 Initial Tread Application

4. Step 4: Install Anti-Slip Treads (Alternative)

   • 1:07–1:32 Initial Tread Application
   • 0:54–1:07 Prepare Anti-Slip Tread
   • 0:51–4:06 Apply Adhesive-Backed Anti-Slip Products

5. Step 5: Secure Edges and Corners

   • 0:28–0:49 Inserting and Securing Anti-Slip Strips
   • 0:51–4:06 Apply Adhesive-Backed Anti-Slip Products
   • 0:02–0:06 Apply Anti-Slip Strip (this video)