How to make Old Concrete look Brand New! (DIY Concrete Resurfacing)
Video by Andrew Thron Improvements · 3 moments used in Oak Valley Designs's DIY guides · 0:59 long

Moments in this video
- 0:13–0:21 Mix Concrete Resurfacing Product
From How to Resurface Worn Concrete Steps, Step 4: Mix and Apply Concrete Resurfacer
Prepare the concrete resurfacing product according to the manufacturer's specific instructions. This typically involves mixing the dry powdered resurfacing material with a precise amount of water and often a liquid additive in a large mixing bucket. Use a drill equipped with a mixing paddle to thoroughly combine the ingredients until the mixture achieves a smooth, consistent texture similar to 'pancake batter', ensuring there are no lumps.
- 0:21–0:39 Apply Thin Layer of Resurfacer
From How to Resurface Worn Concrete Steps, Step 4: Mix and Apply Concrete Resurfacer
Carefully pour the freshly mixed concrete resurfacing product directly onto the prepared concrete surface. Use a concrete hand trowel to spread the mixture evenly across the entire application area. Aim for a thin, consistent layer, approximately 1/16 of an inch (1.5 mm) thick. Repeat this process for all surfaces that need to be revitalized, including the flat top sections of the steps, horizontal treads, and vertical risers of the concrete porch or stairs.
- 0:40–0:45 Apply Broom Finish (Optional)
From How to Resurface Worn Concrete Steps, Step 5: Texture and Finish
If desired, apply a broom finish to the freshly applied resurfacing product while it is still wet. This is done by lightly dragging a concrete finishing broom across the surface. This technique creates a textured look that enhances traction, making the concrete less slippery, especially when wet.
The guide that use this video
Transcript
0:01 here's how to make old concrete look brand new with a concrete resurfacing product here's a look at my existing concrete and to get this project started I first removed the existing railing next I power washed the surface of the concrete to get it nice and clean then remove dust with a blower now it's time to imply our new Crete resurfacing product and to do that I first started by mixing everything up according to the manufacturer instructions then you're going to pour it out on your existing concrete spread it out using a concrete hand trowel and you want to apply a thin layer of the concrete around a sixteenth of an inch to the entire application area repeat this for both the top there and I also did it for the horizontal sections and vertical sections of the stairs on my concrete porch next you can apply a broom finish if you want and this is going to give you a textured look that makes it non-slip and lastly you can apply a concrete sealer
0:47 if you want let's take a quick reminder look at where we started and here's a look at the final result Please Subscribe for more DIY content and check out the full video on YouTube
Automatically transcribed from the source video.
More from the Oak Valley Designs DIY Hub
Read the guide Browse all guides
Planning this project? Shop Oak Valley Designs.

