Supergate® Classic Instructional Video Toddleroo by North States
Video by North States Industries · 2 moments used in Oak Valley Designs's DIY guides · 2:39 long

Moments in this video
- 0:30–0:56 Install Gate (Pressure Mounting)
From How to Install a Pressure-Mounted Gate at the Bottom of Stairs, Step 1: Choose Gate Location
For pressure mounting, position the gate within the desired opening, such as a doorway. Ensure the locking handle mechanism is facing away from the child's side to prevent accidental operation. Gradually expand the gate until all four side bumpers make firm contact with the sides of the opening. To secure the gate, rotate the locking handle into its designated slot. Apply sufficient tension to ensure the gate is snugly held in place and does not easily shift. The handle tab should audibly 'click' into its locked position. To release the gate, press down on the handle, pull it outwards from the slot, and then rotate it upwards.
- 1:16–2:13 Install Gate (Hardware Mounting)
From How to Install a Pet Gate at the Bottom of Stairs, Step 3: Install Mounting Hardware
For a permanent, swinging gate installation, use hardware mounting. First, decide on the desired swing direction, as this will determine the placement of the hinge brackets. Using a tape measure and pencil, mark the precise installation points for the bottom hinge bracket on the wall (refer to the instruction manual for specific measurements, often 3 3/4 to 4 inches from the floor). Secure this bracket to the wall with screws using a screwdriver. Next, measure approximately 20 inches (51.3 cm) directly above the bottom hinge bracket and mark the position for the top hinge bracket. Install the top hinge bracket securely with screws. Once both hinge brackets are in place, align the gate's hinge pins with these installed brackets and slide the gate downwards, seating it firmly onto the hinges. On the opposite side of the opening, with the gate closed, measure and mark the positions for the bottom and top latching brackets, ensuring they align perfectly with the gate's latching mechanism. Finally, attach these latching brackets to the wall with screws.
Guides that use this video
Transcript
0:04 This installation video is a supplement to our North States Supergate Classic instructions. First remove the installation hardware by laying the gate on the floor extending it slightly and sliding the package out while pressing on the opposite side the super gate is extremely versatile and can be mounted in a variety of ways using conventional pressure mounting allows you to move the gate from opening to opening always position the gate in the opening with the locking handle facing away from the child with the handle in the unlocked position expand the gate so all four side bumpers are in contact with the sides of the opening rotate the locking handle into the slot ensuring enough tension to secure the gate the handle tab should click into place to release
0:54 press down pull out and rotate up you can also use the pressure mount with door sockets for additional security prepare the surfaces where the tape pads will be adhered as described in the instructions make sure all door sockets are installed with the u-shaped opening facing up and at equal distances from the edge of the opening if desired screws can be inserted for additional stability the super gate should be Hardware mounted for additional safety at the top of stairs or where attachment to wood or metal surfaces are possible ensure the gate swings over the landing never over the stairs identify which side you want the gate to hinge it will swing in the direction of the hole selected slide the lower gate hinge onto the hinge side as
1:43 shown screwing it on to the gate following the provided installation diagram screw the two casement hinges into the hinge side of the opening place the bottom gate hinge onto the lower casement hinge selecting the appropriate mounting hole to accommodate the desired swing direction then slide the top gate hinge into position with the casing hinge screwing it into the gate on the opposite side of the opening follow the instructions for pressure mounted door sockets be sure to read the instructions thoroughly for recommended installation options including safety precautions for mounting near stairways large openings up to 42 inches with various applications.
2:31 The Supergate Classic from North States
Automatically transcribed from the source video.
More from the Oak Valley Designs DIY Hub
Read the guide Browse all guides
Planning this project? Shop Oak Valley Designs.

