Supergate® Classic Instructional Video Toddleroo by North States
Video by North States Industries · 2 moments used in Oak Valley Designs's DIY guides · 2:39 long

Moments in this video
- 0:30–0:56 Install Gate (Pressure Mounting)
From How to Install a Pressure-Mounted Gate at the Bottom of Stairs, Step 1: Choose Gate Location
For pressure mounting, position the gate within the desired opening, such as a doorway. Ensure the locking handle mechanism is facing away from the child's side to prevent accidental operation. Gradually expand the gate until all four side bumpers make firm contact with the sides of the opening. To secure the gate, rotate the locking handle into its designated slot. Apply sufficient tension to ensure the gate is snugly held in place and does not easily shift. The handle tab should audibly 'click' into its locked position. To release the gate, press down on the handle, pull it outwards from the slot, and then rotate it upwards.
- 1:16–2:13 Install Gate (Hardware Mounting)
From How to Install a Pet Gate at the Bottom of Stairs, Step 3: Install Mounting Hardware
For a permanent, swinging gate installation, use hardware mounting. First, decide on the desired swing direction, as this will determine the placement of the hinge brackets. Using a tape measure and pencil, mark the precise installation points for the bottom hinge bracket on the wall (refer to the instruction manual for specific measurements, often 3 3/4 to 4 inches from the floor). Secure this bracket to the wall with screws using a screwdriver. Next, measure approximately 20 inches (51.3 cm) directly above the bottom hinge bracket and mark the position for the top hinge bracket. Install the top hinge bracket securely with screws. Once both hinge brackets are in place, align the gate's hinge pins with these installed brackets and slide the gate downwards, seating it firmly onto the hinges. On the opposite side of the opening, with the gate closed, measure and mark the positions for the bottom and top latching brackets, ensuring they align perfectly with the gate's latching mechanism. Finally, attach these latching brackets to the wall with screws.
Guides that use this video
More from the Oak Valley Designs DIY Hub
Read the guide Browse all guides
Planning this project? Shop Oak Valley Designs.

