Is there any good way to keep kittens safe in the attic? fariybaby safety door is worth a try.#gate
Video by FairyBaby · 4 moments used in Oak Valley Designs's DIY guides · 0:18 long

Moments in this video
- 0:04–0:06 Position the Gate Frame in Opening
From How to Install a Pressure-Mounted Gate at the Bottom of Stairs, Step 1: Choose Gate Location
Carefully position the main gate frame within the desired opening. In this video, it's installed at the bottom of a stairwell. Ensure the gate is centered horizontally within the opening and that the bottom bar sits flush with the floor or step. The gate may appear slightly narrower than the opening at this stage, which is normal as the pressure mounts will extend to fill the gap.
- 0:04–0:06 Position the Gate Frame in Opening
From How to Install a Pressure-Mounted Gate at the Bottom of Stairs, Step 4: Position Gate and Adjust Height
Carefully position the main gate frame within the desired opening. In this video, it's installed at the bottom of a stairwell. Ensure the gate is centered horizontally within the opening and that the bottom bar sits flush with the floor or step. The gate may appear slightly narrower than the opening at this stage, which is normal as the pressure mounts will extend to fill the gap.
- 0:06–0:09 Adjust and Secure Pressure Mounts
From How to Install a Pressure-Mounted Gate at the Bottom of Stairs, Step 5: Apply Pressure and Secure
Locate the integrated pressure mounting bolts or spindles on all four corners (top-left, top-right, bottom-left, bottom-right) of the gate frame. Begin by hand-tightening each bolt by twisting it until its rubber pad makes initial contact with the wall, door frame, or banister. Then, as shown in the video's close-up (0:06-0:09), use the integrated turning mechanism or adjustment knob on each bolt to gradually and evenly tighten all four pressure points. Alternate tightening between the top and bottom, and left and right sides, applying even pressure until the gate frame is firmly wedged and secure without bowing or damaging the mounting surface.
- 0:09–0:15 Test Gate Security and Latch
From How to Install a Pet Gate at the Bottom of Stairs, Step 5: Adjust and Test Latch Mechanism
Once the gate is fully installed and tightened, thoroughly test its stability by gently pushing, pulling, and shaking the entire frame to confirm it does not move or shift. Operate the gate's latch and opening mechanism several times to ensure it functions correctly and securely, as demonstrated by the woman opening the gate (0:09-0:10) and the cat attempting to pass through but being contained (0:12-0:15). This final verification ensures the gate effectively contains pets or children, providing peace of mind.
Guides that use this video
More from the Oak Valley Designs DIY Hub
Read the guide Browse all guides
Planning this project? Shop Oak Valley Designs.

