Another Simple Solution To A Common Problem Created By Stair Builders - Deck Nosing Or No Nosing
Video by stairbuilding · 3 moments used in Oak Valley Designs's DIY guides · 4:14 long

Moments in this video
- 0:37–1:59 Analyzing Stairway Without Step Nosings (Deck Nosing Present)
From How to Check Your Stairs Against Building Code, Step 5: Inspect Tread Nosing
This step analyzes a stairway design where the individual steps lack a nosing (overhang), but the upper deck, to which the top step connects, has a 1-inch overhang. The presenter clarifies that, according to building codes, the tread measurement for the top step is taken from the farthest protruding section of the deck (including its 1-inch overhang) to the farthest projecting point of the step below. This means that despite the physical step being 11 inches deep, the code-compliant measurement becomes 10 inches for that top step. This creates an inconsistency with the other steps, which have a full 11-inch tread. The presenter notes that this specific scenario (deck having a nosing but steps not) is rare and that most building inspectors might not even catch this subtle discrepancy. He suggests a simple fix for this specific problem: remove the deck board, rip (cut) off the 1-inch overhang, and reinstall it to eliminate the nosing on the deck.
- 2:00–2:24 Analyzing Stairway with Consistent Nosings (Correct Design)
From How to Check Your Stairs Against Building Code, Step 2: Measure Stair Run
This step demonstrates a correctly designed stairway where all steps, including the connection to the upper deck, uniformly feature a 1-inch nosing. Each tread depth is consistently 11 inches, measured from the front of the nosing on one step to the front of the nosing on the step below. This design adheres to building codes for consistent tread depth, ensuring safety and compliance.
- 2:00–2:24 Analyzing Stairway with Consistent Nosings (Correct Design)
From How to Check Your Stairs Against Building Code, Step 5: Inspect Tread Nosing
This step demonstrates a correctly designed stairway where all steps, including the connection to the upper deck, uniformly feature a 1-inch nosing. Each tread depth is consistently 11 inches, measured from the front of the nosing on one step to the front of the nosing on the step below. This design adheres to building codes for consistent tread depth, ensuring safety and compliance.
The guide that use this video
More from the Oak Valley Designs DIY Hub
Read the guide Browse all guides
Planning this project? Shop Oak Valley Designs.

