Test and Finalize Installation

What happens in this clip

After all the pot lights have been properly installed and secured in their respective ceiling openings, return to the main electrical panel. Carefully switch the circuit breaker back to the 'ON' position. Test each newly installed pot light by activating its corresponding wall switch to ensure it illuminates correctly. If any fixture does not light up, turn off the power immediately, return to the fixture, and meticulously re-check all electrical connections and the LED module for any potential issues or damage.

Goal: Restore power to the circuit, test all newly installed pot lights, and troubleshoot any non-functional fixtures.

What's used

Tools

• Non-contact Voltage Tester Klein Tools

About the full video

This video provides a brief introduction to the readiness of electrical wiring for recessed lighting (often called pot lights or can lights) in a new construction or renovation project. It highlights the completed rough-in phase where wires are hanging from the ceiling, awaiting the final installation (trim out) of energy-efficient LED pot light fixtures. This guide details the steps involved in performing the 'trim out' to install LED pot lights, ensuring bright, long-lasting illumination.

Step 6 of 7: Restore Power and Test

Once all fixtures are installed and connections are made, return to the electrical panel and turn the breaker back on for the circuit you were working on. Test each light to ensure it illuminates correctly. If any light does not work, turn the power off again and re-check all wiring connections.

Open this step in the guide

Every video in How to Install Recessed Step Lights in a Stairwell Wall

1. Step 1: Plan Light Layout

   • 0:34–0:49 Mark Light Placement
   • 5:10–6:00 Integrate Stair Niche Lights
   • 0:00–0:27 Planning and Safety

2. Step 2: Cut Fixture Openings

   • 0:04–0:10 Mark and Cut Drywall Hole
   • 0:00–0:01 Trace Cutout with Template
   • 0:17–0:22 Cut the Ceiling Hole

3. Step 3: Run Electrical Wire

   • 0:59–1:18 Run Electrical Wires
   • 4:35–5:25 Run New Electrical Wires
   • 1:57–2:46 Run Electrical Wires to Light Fixtures

4. Step 4: Connect Fixtures to Power

   • 2:01–3:49 Connect Electrical Wires
   • 0:41–0:51 Connect Electrical Wires
   • 0:00–0:02 Connect Electrical Wires to Fixture

5. Step 5: Install Light Fixtures

   • 4:51–5:50 Mount the Fixture in the Ceiling
   • 0:18–0:22 Install Recessed Light
   • 0:11–0:18 Connect and Install Recessed Light Fixture

6. Step 6: Restore Power and Test

   • 0:00–0:30 Test and Finalize Installation (this video)
   • 1:36–1:44 Restore Power and Test Functionality
   • 0:24–0:26 Test New Lighting System

7. Step 7: Finishing Touches

   • 0:16–0:33 Install Decorative Trim
   • 2:19–2:48 Install Trims
   • 2:19–2:28 Final Installation and Snap into Place