Initial Tread Application

What happens in this clip

To begin applying the tread, first wash your hands thoroughly to remove any skin oils, which could affect the adhesive. Carefully peel back approximately 3 to 4 inches (7.6 to 10.2 cm) of the backing paper from one end of the anti-slip tread. Create a fold in the peeled backing paper, being cautious not to touch the exposed adhesive. Line up the center mark or crease on the anti-slip tread with the pencil mark on the masking tape on the stair. Once aligned, carefully place down the peeled portion of the tread onto the stair. Using the provided roller, press down firmly on this initial section to secure it and begin removing any air bubbles.

Goal: Partially apply the anti-slip tread, ensuring proper alignment and initial adhesion.

What's used

Tools

• Anti-slip stair tread Slips Away
• Roller
• Squeegee

About the full video

This video provides step-by-step instructions on how to easily install anti-slip stair treads on hardwood stairs, covering essential preparation, precise measurement for alignment, and proper application techniques to ensure a secure and bubble-free finish.

Step 3 of 4: Apply Anti-Slip Treatment

There are several types of anti-slip treatments available. Choose one that suits your needs and aesthetic preferences, such as anti-slip tapes, clear anti-slip coatings, or textured paint. For tapes, carefully measure and cut each strip to fit the tread, leaving a small gap from the edges to prevent peeling. For coatings or paints, apply thin, even coats using a brush, roller, or spray, following the product's specific application instructions. Allow adequate drying time between coats as recommended by the manufacturer.

Open this step in the guide

Every video in How to Stop Slipping on Hardwood Stairs in Socks

1. Step 1: Clean the Stair Treads

   • 0:34–0:40 Clean the Stairs
   • 0:04–0:07 Clean the Staircase
   • 0:18–0:31 Clean the Stairs

2. Step 2: Sand the Stair Treads (Optional)

   • 0:46–0:59 Spray Clear Anti-Slip Coating

3. Step 3: Apply Anti-Slip Treatment

   • 0:02–0:06 Apply Anti-Slip Strip
   • 0:46–0:59 Spray Clear Anti-Slip Coating
   • 1:07–1:32 Initial Tread Application (this video)

4. Step 4: Allow Treatment to Cure

   • 0:24–0:30 Allow for Curing
   • 1:07–1:26 Allow Curing & Access Product Information
   • 0:39–0:46 Allow Tuff Grip to Dry and Cure