powered by

When do you need new tires? Part 5

Video by Danny Johnson’s Garage · 1 moment used in Oak Valley Designs's DIY guides · 2:56 long

Moments in this video

  1. 0:08–0:51 Measure Tread Depth on Standard Passenger Tires From How to Check Your Stairs Against Building Code, Step 4: Check for Consistent Tread Depth (Run)

    Utilize a tire tread depth gauge to accurately measure the remaining tread on your standard passenger tires. To get a reliable reading, insert the probe of the gauge into the deepest part of a major tread groove, ensuring that the base of the gauge rests firmly and flat across two adjacent tread blocks. It's crucial to take multiple measurements across the width of the tire's tread to check for even wear. Measure at a minimum of three distinct points: the outer edge, the center, and the inner edge of the tread. The video demonstrates this process, showing readings of approximately 7/32nds of an inch on the outer edge, 5/32nds in the middle, and 6/32nds on the inner edge of the tire. Compare these measured depths against the legal minimum tread depth (which is typically 2/32nds of an inch in many regions) and any specific recommendations from your tire manufacturer or vehicle's owner's manual for optimal safety and performance.

The guide that use this video

Transcript

0:01 life. So, if you see that cracking, that's kind of an indication and this particular car sits outside a lot in the sun. So, it's really not too bad on tread depth per se. This particular tire here. A little bit over 6 32nds. And then in the middle 5 32nds. And then on the other edge And about the 6 32nds again. So, not horrible but uh definitely just this brand of

0:47 tire looks like it's prone to some dry rotting. All right, now let's look at the Cobra. Believe it or not, when I first got these tires brand new, I went in for a inspection and they freaked out and they said, "Your tires are bald." And I said, "Well, not really. These are drag radials. They are DOT approved. They are street legal. And if you measure them now, though from where we are today they're down to about that 4 32nds. So, they're on that not necessarily need to be replaced 100% but they're getting really, really close. So, they're I'm getting close. It just depends on where you measure it.

1:33 Um something to note on these tires is the tread wear. So, these are Mickey Thompson ET Street drag radials. So, they're super soft. They're designed that way so that they'll get sticky and they'll basically melt and give you traction for that. But uh here's what you want to see. Here's the tread wear. 0 0 0. So, basically no treadwear. Other tires I've seen like on the 22-in wheels that we had on our Yukon had a wear pattern or a treadwear of like 1,200. So, 400 is kind of a normal one for passenger tires. So, as you can see, 000, these ones are definitely designed

2:20 for performance, not to be driven in the rain, and they're just going to basically the just melt and give you a some sticky traction. So, going back to the Tundra, just to show you this again. So, here's our treadwear for this one. 600 So, thanks for watching. Please check the video description for more videos that are similar to this. I have another one explaining more of the date codes and things like that that I'll put in the description. And we'll catch you guys on the next video. Thanks, guys.

Automatically transcribed from the source video.

More from the Oak Valley Designs DIY Hub

Read the guide Browse all guides

Planning this project? Shop Oak Valley Designs.

When do you need new tires? Part 5 — step-by-step moments | Oak Valley Designs

Subscribe for exclusive updates

Be the first to know about promotions, new products, and sales.