Installing Cable Railings Like a Pro #deckbuilder #construction #carpentry
Video by drdecks · 2 moments used in Oak Valley Designs's DIY guides · 0:40 long

Moments in this video
- 0:10–0:20 Uncoiling and Initial Cable Threading
From How to Tension and Adjust Stair Cable Railing, Step 1: Initial Cable Engagement
The workers begin by uncoiling a large spool of stainless steel cable. Once uncoiled and straightened, the cable is carefully threaded through the pre-drilled holes in the railing posts. This process often starts at one end of a cable run, pulling the cable through several intermediate posts to ensure it runs smoothly and without kinks. It is advisable to wear work gloves to protect hands from potential cuts from the cable strands.
- 0:25–0:35 Attaching and Initial Tightening of Tensioning Terminals
From How to Tension and Adjust Stair Cable Railing, Step 3: Install Tensioning Device at Opposite End
At the opposite end of each cable run, a tensioning terminal is attached. These fittings typically include a threaded component that allows for tightening the cable. The worker is clearly shown using wrenches to screw in and tighten these tensioners. The cable is inserted into the tensioning fitting, and then the assembly is tightened to pull the cable taut. This process is repeated for each cable until all cables have their tensioning terminals installed and have some initial tautness.
The guide that use this video
More from the Oak Valley Designs DIY Hub
Read the guide Browse all guides
Planning this project? Shop Oak Valley Designs.

