Mount the Bracket to the Wall

What happens in this clip

Determine the correct height and location on your wall for the safety gate. Place the finished bracket against the wall at this spot. Using a drill with a screw, secure the bracket firmly to the wall. Ideally, drive the screw into a wall stud for maximum stability. Even a single screw into a stud should be sufficient to hold the bracket securely.

Goal: Securely attach the custom bracket to the wall

What's used

Tools

• Drill RIDGID
• Screw
• Stud Finder

Materials

• Assembled Bracket

About the full video

This DIY project guides you through creating custom, secure mounting brackets for child and pet safety gates. These brackets address common issues with standard pressure-mounted gates, such as damage to drywall walls and insufficient security against pushing or pulling. By using a molding block and hardwood backing, the project provides a sturdy bayonet-style mount that protects your walls and keeps the gate firmly in place, enhancing safety for children and pets.

Step 2 of 4: Attach Gate Mounting Plate to Wall Stud

Locate a wall stud adjacent to the banister where the gate will be installed. Use a stud finder to ensure accuracy. Position the gate's mounting plate over the identified stud at the correct height, aligning it with the banister clamp mounts. Mark the screw hole locations on the wall. Pre-drill pilot holes at the marked locations. Then, attach the mounting plate to the stud using the provided lag screws, ensuring it is firmly secured and plumb.

Open this step in the guide

Every video in How to Install a Baby Gate at the Top of Stairs Without Drilling into the Banister

1. Step 1: Install Banister Clamp Mounts

   • 0:27–0:33 Attach Clamps to the Banister Post
   • 0:14–0:26 Understand the No-Holes Banister Installation Kit
   • 0:43–1:10 Install Baby Gate and Verify Compatibility

2. Step 2: Attach Gate Mounting Plate to Wall Stud

   • 0:31–0:56 Position Gate and Install Upper Wall Mounts (First Side)
   • 0:24–0:31 Install Lower Wall Mounts (First Side)
   • 3:14–3:37 Mount the Bracket to the Wall (this video)

3. Step 3: Assemble and Install Gate Hardware

   • 2:15–2:40 Install Spindles and Final Gate Mounting
   • 5:29–6:07 Install Gate to Staircase
   • 1:11–1:37 Install Spindle Rods and Position Gate

4. Step 4: Test Gate Stability and Latch Function

   • 0:03–0:05 Test Gate Latch and Swing
   • 17:06–18:29 Test Gate Functionality and Latch
   • 1:51–1:59 Test Gate Operation