Install Lower Wall Mounts (First Side)

What happens in this clip

The installer begins by marking the desired position for the lower wall mounts on one side of the stairway opening. He then uses a cordless drill to create pilot holes in the wall or baseboard. Following this, he securely attaches the plastic wall mounts using screws, ensuring they are firmly in place. These mounts will serve as the anchor points for the gate.

Goal: Secure the lower wall mounts for the gate's first side

What's used

Tools

• Cordless Drill Milwaukee
• Manual screwdriver (for screws only)
• Drill Bit Unspecified
• Pencil/Marker Unspecified
• Screwdriver Bit Unspecified
• Screws Unspecified
• Wall Mounts (plastic) Unspecified

About the full video

This project provides a step-by-step guide on how to install a configurable plastic safety gate at the top of a steep carpeted stairway. The process involves marking and securely attaching wall mounts, assembling the gate panels, and finally securing the gate to these mounts to prevent access to the stairs.

Step 2 of 4: Attach Gate Mounting Plate to Wall Stud

Locate a wall stud adjacent to the banister where the gate will be installed. Use a stud finder to ensure accuracy. Position the gate's mounting plate over the identified stud at the correct height, aligning it with the banister clamp mounts. Mark the screw hole locations on the wall. Pre-drill pilot holes at the marked locations. Then, attach the mounting plate to the stud using the provided lag screws, ensuring it is firmly secured and plumb.

Open this step in the guide

Every video in How to Install a Baby Gate at the Top of Stairs Without Drilling into the Banister

1. Step 1: Install Banister Clamp Mounts

   • 0:27–0:33 Attach Clamps to the Banister Post
   • 0:14–0:26 Understand the No-Holes Banister Installation Kit
   • 0:43–1:10 Install Baby Gate and Verify Compatibility

2. Step 2: Attach Gate Mounting Plate to Wall Stud

   • 0:31–0:56 Position Gate and Install Upper Wall Mounts (First Side)
   • 0:24–0:31 Install Lower Wall Mounts (First Side) (this video)
   • 3:14–3:37 Mount the Bracket to the Wall

3. Step 3: Assemble and Install Gate Hardware

   • 2:15–2:40 Install Spindles and Final Gate Mounting
   • 5:29–6:07 Install Gate to Staircase
   • 1:11–1:37 Install Spindle Rods and Position Gate

4. Step 4: Test Gate Stability and Latch Function

   • 0:03–0:05 Test Gate Latch and Swing
   • 17:06–18:29 Test Gate Functionality and Latch
   • 1:51–1:59 Test Gate Operation