Mix Concrete Patching Compound

What happens in this clip

If using the powder-based Quikrete Vinyl Concrete Patcher, add water gradually to the powder in a mixing bucket. Continue mixing until the compound achieves a 'fine and smooth peanut butter texture.' It should be thick enough to hold its shape but spreadable. The presenter wears gloves during mixing.

Goal: Achieve desired consistency for patching mix

What's used

Tools

• Bucket Unknown (repurposed Ecolab bucket)
• Wheelbarrow
• Gloves Holmes
• Work gloves
• Mixing tool
• Stirring stick
• Drill with mixing paddle

Materials

• Quikrete Vinyl Concrete Patcher Quikrete
• Water

About the full video

This project details the process of repairing chipped concrete driveways, common in areas with harsh winters. It covers material selection, thorough surface preparation using a pressure washer and wire brush, proper mixing and application of a vinyl concrete patching compound, and final smoothing for a durable repair.

Step 3 of 6: Mix the Concrete Repair Compound

Read the instructions on the concrete repair compound packaging carefully. In a clean mixing container, add the specified amount of powder and then slowly add the recommended amount of water. Mix thoroughly with a trowel or mixing paddle until a smooth, consistent, workable paste is achieved. Avoid mixing more than you can use within the product's pot life.

Open this step in the guide

Every video in How to Repair a Chipped Concrete Step Edge

1. Step 1: Clean the Chipped Area

   • 0:12–0:55 Clean and Prepare the Damaged Area
   • 0:46–1:13 Clean Out Debris and Loose Chunks
   • 1:36–3:50 Clean Out Loose Concrete and Debris

2. Step 2: Undercut the Edge (if necessary)

   • 0:46–1:13 Clean Out Debris and Loose Chunks
   • 1:36–3:50 Clean Out Loose Concrete and Debris
   • 0:43–1:02 Prepare Damaged Concrete and Install Forms

3. Step 3: Mix the Concrete Repair Compound

   • 0:39–0:49 Mix Patching Cement
   • 1:41–1:54 Mix Concrete Patching Compound (this video)
   • 1:03–2:18 Mix the Concrete Patcher

4. Step 4: Apply the Repair Compound

   • 1:55–2:11 Apply Concrete Patch to Chips
   • 1:15–4:04 Apply Two-Part Epoxy Filler
   • 1:32–1:46 Fill Damaged Areas

5. Step 5: Shape and Finish the Surface

   • 3:40–5:58 Smooth and Finish Concrete Step Repair
   • 0:52–1:02 Smooth and Finish Concrete Patch
   • 3:15–5:02 Shape and Texture the Patch

6. Step 6: Cure the Repair

   • 0:37–0:46 Cure and Protect the Repaired Area
   • 0:28–0:29 Allow Compound to Cure
   • 11:58–12:06 Cure and Protect Repaired Steps