Measure Winder Steps Width

What happens in this clip

After measuring the depth, measure the width of each winder step. This is typically the widest part of the step. Place the tape measure at the furthest corner on one side and extend it to the furthest corner on the opposite side. Do not measure only the narrowest front edge, as this will lead to insufficient material. Always measure the furthest points of the step's width. Add extra material (e.g., 6 inches) to these width measurements as well.

Goal: Measure the widest point of each winder step, from the furthest edge to the opposite furthest point.

What's used

Tools

• Notebook/Paper
• Pencil
• Tape Measure

About the full video

This video provides detailed instructions on how to measure winder stairs (angled or pie-shaped steps) for carpet installation, considering pile direction and allowing for extra material during cuts. It covers measuring top landings, straight stairs, winder steps, and half landings, culminating in creating a custom carpet plan based on these precise measurements.

Step 3 of 6: Measure Tread Width

Using your tape measure, determine the width of each tread. Measure from the outermost visible edge on one side to the outermost visible edge on the other side. Note any variations in width, which might occur if the stairs are not perfectly symmetrical. This measurement is critical for cutting the new treads to fit.

Open this step in the guide

Every video in How to Measure Outdoor Stairs for Treads

1. Step 1: Inspect Existing Stair Structure

   • 0:00–0:13 Assess Existing Stairs and Planning
   • 0:00–0:59 Assess Existing Unsafe Staircase
   • 0:00–0:12 Remove Old Stairs and Assess Site

2. Step 2: Measure Tread Depth

   • 0:31–1:01 Measure Riser Height and Tread Depth Consistency
   • 0:00–0:03 Measure Individual Stair Components
   • 0:55–1:05 Measure and Cut First Tread

3. Step 3: Measure Tread Width

   • 0:21–0:53 Measure Stair Tread Width
   • 0:00–0:03 Measure Individual Stair Components
   • 7:25–8:46 Measure Winder Steps Width (this video)

4. Step 4: Measure Riser Height

   • 1:44–2:33 Calculate Riser Height (Option 2) and Verify Code Compliance
   • 1:24–1:56 Repeat for All Risers and Measure Variation
   • 4:32–5:10 Calculate Individual Riser Height

5. Step 5: Check for Stair Squareness and Level

   • 1:11–2:23 Identify and Measure Out-of-Square Deviations
   • 12:00–14:21 Check Tread Level and Stringer Fit
   • 0:18–0:24 Verify Overall Frame Squareness, Plumb, and Level

6. Step 6: Document All Measurements and Irregularities

   • 3:09–4:52 Record All Measurements on Template
   • 0:00–0:03 Measure Individual Stair Components
   • 1:36–2:16 Measure Worn Sections for Code Compliance