Measure Individual Stair Components

What happens in this clip

To start, use a reliable tape measure to determine the dimensions of your stairs. First, measure the **width of a single stair tread** from wall to wall or from stringer to stringer (the side supports of the staircase). In the video, the individual measures the width of a stair tread using a tape measure. Record this measurement carefully. Next, measure the **depth of the stair tread**, which is the horizontal surface where you step. Finally, measure the **height of the stair riser**, which is the vertical part of the stair. It is crucial to measure several steps, especially if there are variations, and use the largest measurements to ensure sufficient material coverage for all stairs. Also, count the total number of individual stairs, including any landings that might require carpet.

Goal: Begin by accurately measuring the width, tread depth, and riser height of a typical stair in your staircase. These foundational measurements are critical for calculating the total material needed for both underlayment and carpet.

What's used

Tools

• Notepad and Pen
• Pencil/Marker
• Tape Measure

About the full video

This detailed guide outlines the essential steps for accurately measuring stairs to determine the precise quantity of carpet and underlayment required for installation. It covers individual stair component measurements, the application of specific formulas to calculate material lengths per step, and the subsequent marking and cutting of underlayment and carpet strips. The process aims to minimize material waste and ensure a professional, well-fitted stair carpet installation.

Step 3 of 6: Measure Tread Width

Using your tape measure, determine the width of each tread. Measure from the outermost visible edge on one side to the outermost visible edge on the other side. Note any variations in width, which might occur if the stairs are not perfectly symmetrical. This measurement is critical for cutting the new treads to fit.

Open this step in the guide

Every video in How to Measure Outdoor Stairs for Treads

1. Step 1: Inspect Existing Stair Structure

   • 0:00–0:13 Assess Existing Stairs and Planning
   • 0:00–0:59 Assess Existing Unsafe Staircase
   • 0:00–0:12 Remove Old Stairs and Assess Site

2. Step 2: Measure Tread Depth

   • 0:31–1:01 Measure Riser Height and Tread Depth Consistency
   • 0:00–0:03 Measure Individual Stair Components
   • 0:55–1:05 Measure and Cut First Tread

3. Step 3: Measure Tread Width

   • 0:21–0:53 Measure Stair Tread Width
   • 0:00–0:03 Measure Individual Stair Components (this video)
   • 7:25–8:46 Measure Winder Steps Width

4. Step 4: Measure Riser Height

   • 1:44–2:33 Calculate Riser Height (Option 2) and Verify Code Compliance
   • 1:24–1:56 Repeat for All Risers and Measure Variation
   • 4:32–5:10 Calculate Individual Riser Height

5. Step 5: Check for Stair Squareness and Level

   • 1:11–2:23 Identify and Measure Out-of-Square Deviations
   • 12:00–14:21 Check Tread Level and Stringer Fit
   • 0:18–0:24 Verify Overall Frame Squareness, Plumb, and Level

6. Step 6: Document All Measurements and Irregularities

   • 3:09–4:52 Record All Measurements on Template
   • 0:00–0:03 Measure Individual Stair Components
   • 1:36–2:16 Measure Worn Sections for Code Compliance