powered by

Outside Corner molding Installation (EASIEST WAY)

Video by VCG Construction · 1 moment used in Oak Valley Designs's DIY guides · 0:47 long

Moments in this video

  1. 0:12–0:19 Cut Miter Joints for Outside Corner From How to Install Baseboard Along a Staircase Wall, Step 5: Cut Inside and Outside Corners

    Once the trim board is marked, take it to a miter saw. For an outside 90-degree corner, each piece of trim will require a 45-degree miter cut. Adjust the miter saw to a 45-degree angle. Ensure the cut is made on the correct side of the pencil mark to account for the angle and the length of the trim. The two 45-degree cuts from each trim piece will join together to form a crisp 90-degree outside corner. After cutting, test-fit the two pieces together to ensure a tight seam.

The guide that use this video

Transcript

0:01 we now have an outside corner to make and the best way to get a measurement for an outside corner is to basically take your trim board hold it in place mark it with a pencil or using a board long enough that we could make both sides of our cut we'll take it over to our saw make our cuts and we'll return I'm going to test fit it in place see if we have what we need with all outside corners you're going to want to glue and in this instance we are actually pre-assembling our outside corner and then installing in place we then put it in place by spreading some adhesive on it and then put pin nails to hold it into the masonry wall let's get started with our base cap we're pretty much going to follow the same room team we're not going to be four to five in those inside Corners because we're going to be coping those inside corn

Automatically transcribed from the source video.

More from the Oak Valley Designs DIY Hub

Read the guide Browse all guides

Planning this project? Shop Oak Valley Designs.

Outside Corner molding Installation (EASIEST WAY) — step-by-step moments | Oak Valley Designs

Subscribe for exclusive updates

Be the first to know about promotions, new products, and sales.