Install a Motion Sensor Light Switch in 2 Minutes
Video by Start at Home · 2 moments used in Oak Valley Designs's DIY guides · 0:22 long

Moments in this video
- 0:05–0:11 Wire New Motion Sensor Switch
From How to Install a Motion-Sensor Light Switch in a Stairway, Step 4: Connect Motion Sensor Switch - Line and Load
The video briefly shows the wiring diagram provided with the motion sensor wall switch, indicating connections for black (line/load), white (neutral), and green/bare (ground) wires. Following these instructions, connect the new motion sensor switch (e.g., a Lutron model is visible) to the existing electrical wires in the wall box. Typically, the two black wires from the wall are connected to the designated black wires on the switch, the white neutral wire from the wall is connected to the white neutral wire on the switch (if present), and the bare copper or green ground wire from the wall is connected to the green ground wire on the switch. Secure all connections using wire nuts, twisting them clockwise until tight to ensure no bare wire is exposed.
- 0:11–0:12 Mount Motion Sensor Switch
From How to Install a Motion-Sensor Light Switch in a Stairway, Step 6: Mount the Motion Sensor Switch
Once the wires are securely connected, carefully push the wired motion sensor switch back into the electrical box. Use the screws provided with the switch to secure it to the electrical box. Finally, attach the new cover plate over the switch, ensuring it is flush with the wall and that the switch toggle/sensor is properly exposed.
The guide that use this video
More from the Oak Valley Designs DIY Hub
Read the guide Browse all guides
Planning this project? Shop Oak Valley Designs.

