How to Install a Louisville Attic Ladder (EASY DIY Step-by-Step!)
Video by The Excellent Laborer · 2 moments used in Oak Valley Designs's DIY guides · 12:54 long

Moments in this video
- 0:21–1:52 Measure the Attic Opening and Ceiling Height
From How to Trim Attic Ladder Legs to the Right Length, Step 1: Measure Ladder Leg Length
The first step is to determine the correct opening size for the attic ladder. Measure the width of the existing opening, specifically between the trusses. In this video, the opening measured 22.5 inches. This width is crucial as most trusses are set 24 inches on center, providing a standard 22.5 inches between them. Next, measure the length of the opening, which was 63 inches in this case. Finally, measure the distance from the ceiling to the floor (ceiling height). This measurement will dictate the required length of the attic ladder, as ladders come in various lengths to accommodate different ceiling heights (e.g., 54" L x 22.5" W for 8-9' ceilings, 63" L x 22.5" W for 10-12' ceilings). This particular installation is for a ceiling over 10 feet high, requiring a longer ladder that can extend up to 12 feet.
- 7:46–8:35 Trim the Ladder to Length
From How to Trim Attic Ladder Legs to the Right Length, Step 1: Measure Ladder Leg Length
Extend the attic ladder fully until it touches the floor. The ladder will be too long at this point. Measure the required length by extending a tape measure from the top of the attic opening (where the ladder attaches) down to the floor, ensuring the ladder is at its proper angle. For this installation, the required length to reach the floor correctly was about 36.5 inches from the bottom hinge. Fold the ladder back up and mark the cut line on the bottom section. Use a reciprocating saw (Sawzall) or a hacksaw to cut off the excess length from the bottom sections of the ladder. Remember to wear safety glasses when cutting metal.
The guide that use this video
More from the Oak Valley Designs DIY Hub
Read the guide Browse all guides
Planning this project? Shop Oak Valley Designs.

