How to Fix A Squeaky Floor
Video by The Fixer · 1 moment used in Oak Valley Designs's DIY guides · 11:52 long

Moments in this video
- 8:01–8:29 Test Repaired Floor
From How to Use a Squeak-Repair Kit on Carpeted Stairs and Floors, Step 6: Test the Repaired Area
Walk firmly over the areas that previously squeaked. Listen carefully to confirm that the floor is now solid and quiet. If any minor squeaks persist, repeat the process of locating and securing those specific spots with additional screws.
The guide that use this video
Transcript
0:00 I have a squeaky floor. So we're gonna fix that right now. So here I am in my kitchen and I threw down these cheap stick tiles to cover the floor that was here before. But this section right here is just really annoying. And I just want to fix that. And this video might be a little specific to if you have stick tiles or it might even work for a laminate. But as with all my videos this is just kind of showing you a way of thinking where you can fix your own house. It might
0:47 not be exact to what you have your situation but it might give you an idea of how to fix something like this. So let's get started. And I'm in the basement right now and what you have for floor is you have these floor joists and then you have decking that goes on top of that. That's the original decking. But I don't believe that this floor is squeaking. I believe it's the floor on top of that. So we're gonna try and fix at least that spot. And like I said, hopefully this will give you a good idea of how to fix your own squeaky floor. So there's a lot of spots in my floor that are squeaky. But this one is for sure a big
1:33 trouble spot. So for my floor specifically I'm gonna pull a tile up and try and hold that floor back down. So first thing I'm gonna do is clean this because I don't want any stuff getting stuck under this tile when I take it up and put it back down. So I'm just gonna clean the dirt around it. You can vacuum do whatever you need to do. And I do want to say that this is not like a nice finished floor where I really care about it. So this is kind of a temporary fix or kind of a you know a good enough fix. So we'll see what we can do with this. I'm gonna take a razor blade and just put it right in the edge of this tile and
2:25 try and just peel it up a little bit. Just get a corner up and then I can grab it with my fingers and if this doesn't come up easy for you you can definitely use a hairdryer. A hairdryer would probably help to loosen the adhesive that holds this down. You're gonna see the beautiful floor underneath here that I'm covering up with these cheap tiles. We'll get that. 70's called. Alright so
3:13 there's my tile and remember which way you put it down so you can or took it up so you can put it down the same way. And basically all I'm gonna do is I'm gonna take some screws and I'm gonna run them down. So I'm gonna take some inch and five eighth screws. That should be enough to get through. I know this is five eighths underneath here and then you got this which is about an eighth this vinyl. So I'm gonna take these screws and just run them down. And if you notice downstairs there were gaps in between the floor so this is kind of a guessing game. So I think I might have hit a gap right there so I'm gonna try and
4:01 move over this way and try not to get a gap. There we go. And I'm gonna make sure to set the head on these things so that when I put my tile down it'll sit nice and flat. Make sure there's no little little burrs hanging out here to raise the tile. And just as a little tip if you are doing this on like a linoleum floor that you don't really care about and the squeaky floor bothers you more than the look of the flooring. What you can do is take a knife and just kind of cut a little section out carefully. And then you can just peel that back like
4:54 this. Say this is your finished floor. Just really carefully peel that back and take a screw and run the screw in. And then you can take some super glue or construction adhesive and just kind of put that flooring back carefully tap it back into place. And it covers up pretty good. Like I said you don't want to do this on a super expensive floor or anything but if you're okay with doing that then that might help out. Also if you feel like you want to run longer
5:40 screws you might get a chance of running into a floor joist and that would help suck this thing right down. So that's what I'm gonna do. These are two and a half inch screws. I'll see if we can get a little more wood to grab onto. I'll do one right here. There we go. Make sure all the little shavings are out of there or at least in the screw hole. Do a couple more. All right. Got a couple screws in there. Now we can put our tile back right where it was. Make sure
6:27 these are all sunk in, counter sunk in all the way. Make sure there's no debris and put our tile back nice and easy. Tiles back in place. Let's see how we did. Okay so now I'm in the basement and I can see where all the screws came through and I was right that that was a gap in the flooring and I can tell that this is in the middle of two joists and basically that long screw what I'm gonna do since I
7:17 know it's the actual original decking. I'm gonna take that screw as my reference point. I'm gonna say okay those are by three screws that I put in right there. Then I'm gonna take the long screw and I'm gonna move it over. I'm gonna measure and get that board right here because I think that's the issue. If you see there's a gap in there and then I'm gonna move that screw back and get into this floor joist and I'm hoping that that will tighten up and stop the squeak. And I felt that definitely went into the floor joist. Let's see. Hey look
8:09 at that. I got a little squeak but that's back further this way. Do you remember what it was like before? There's no squeak there so that is awesome. So it took a little work finding the floor joist. I honestly thought I could just get into the original decking but that was what I needed to do to tighten that up. So if you're you have an open basement and you can do that that's great. I know a lot of you aren't gonna have that particular situation but hopefully like I said this gives you an idea of how you can fix stuff like this and I can go around and now I can measure off of that screw and go this way 16 inches if because this
8:59 is frame 16 inches on center so you can do it that way or you can just keep doing trial and error like I was doing put a screw in go see where it came out even do a pilot bit with a just a drill bit and see where it is in the basement and I hope that helps out. Now that I know that the squeaking was coming from the original decking down here I have another tactic you could try and it would actually work better for if you have a nice finished floor here that you didn't want to disturb at all so let's try that I'm gonna go over so this is where the squeak was and then if you go right over here there's another squeak one bay over so let's try and get rid of this. All right so this is the next bay over my squeak that I fixed
9:51 is over here and what I have is a cleat I'm gonna install a cleat just a block of wood um that I'm gonna put like this against this floor joist attach screws into the floor joist and then attach screws up into the floor. I'm hoping I can get screws far enough back in here it's kind of a tight squeeze with this frame in and everything but we're gonna try and uh make this work just make sure when you do this that you're not getting screws that are so long that you're stabbing someone's toes um like I said there's uh this is three quarter in those five baits up here I'm using two and a half inch screws and I think this is an inch and a half block
10:42 and uh we're gonna screw it in see what happens there we go all right like I said it was a tight squeeze in here but I was able to get a couple screws up and a couple screws in this way so let's see if this actually stopped the squeak still a little squeak but it's way better and I could probably put a couple more screws in there and be all set so if you enjoyed this video please give it a like if you haven't subscribed already please do so and check out my links in the description to my facebook instagram and patreon page if you want to see more videos like this you
11:30 can click here and hearish thanks for watching as always and we'll see you next time up into the flooring and I'm hoping I can get that's done forever I'm hoping I can get screwed
Automatically transcribed from the source video.
More from the Oak Valley Designs DIY Hub
Read the guide Browse all guides
Planning this project? Shop Oak Valley Designs.

