powered by

How to Add a 3 Way Switch To an Existing Single Switch Location

Video by The Home Improvement Channel · 1 moment used in Oak Valley Designs's DIY guides · 8:06 long

Moments in this video

  1. 5:22–7:16 Wire the Primary Three-Way Switch From How to Wire a 3-way Switch for Stair Lights at the Top and Bottom, Step 4: Install new 3-way switches

    At the original switch location, you will have the incoming power cable (likely 12/2 or 14/2), the cable running to the light fixture (also 12/2 or 14/2), and the newly run 12-3 (or 14-3) cable to the secondary switch. First, identify the incoming 'hot' wire from the power source (usually black) and connect it to the common (black) screw terminal of your new primary three-way switch. Next, take the hot wire that runs to the light fixture (often black) and connect it to the white wire from the 12-3 cable that goes to the secondary switch. Remember to mark the white wire from the 12-3 with black tape on both ends to denote it's now a 'hot' conductor (common to the secondary switch). Finally, connect the red and black wires from the 12-3 cable to the two traveler (brass) screw terminals on the primary three-way switch. All bare copper ground wires from all cables in the box should be twisted together with a pigtail to the green ground screw on the switch, and all white neutral wires should be twisted together and capped with a wire nut. (Note: The video does not show neutrals being tied to the switch itself, only to each other, as is typical for dead-end three-way switches where the switch does not require a neutral connection.)

The guide that use this video

More from the Oak Valley Designs DIY Hub

Read the guide Browse all guides

Planning this project? Shop Oak Valley Designs.

How to Add a 3 Way Switch To an Existing Single Switch Location — step-by-step moments | Oak Valley Designs

Subscribe for exclusive updates

Be the first to know about promotions, new products, and sales.