powered by

DON'T FORGET THIS STEP!!! Stair Riser Install Tip

Video by Insider Carpentry - Spencer Lewis · 1 moment used in Oak Valley Designs's DIY guides · 0:53 long

Moments in this video

  1. 0:19–0:51 Level and Align Installed Riser From How to Measure Basement Stairs with Uneven Steps, Step 4: Check for Plumb and Level of Treads and Risers

    After a riser has been installed, use a spirit level to check its straightness across its length. If there's a slight gap or unevenness (e.g., a 1/16th gap as mentioned in the video), gently tap the riser with a hammer until the bubble on the level indicates it is perfectly straight and flush. This ensures the top edge of the riser is aligned correctly. The presenter also mentions that the riser will eventually be screwed from the backside to further secure it to the tread, but this step focuses on leveling the top edge.

The guide that use this video

Transcript

0:03 now one of the keys whenever you install your stringers and like what I did here where I had to nail on blocks to the risers you want to ensure that your Center Stringer is a little further in than your outside stringers that'll make it a little bit easier for the whole installation so now here I want to check after I nail my Riser on I've got my level on here I've got a solid 16th Gap I want to go ahead and tap that out and get this nice and straight the whole way across now we will be screwing the Riser from the back side as well that'll draw it close to the tread but we also want to ensure that this top Edge is straight so another step that's very important use a level and get that nice and

0:50 straight all the way across

Automatically transcribed from the source video.

More from the Oak Valley Designs DIY Hub

Read the guide Browse all guides

Planning this project? Shop Oak Valley Designs.

DON'T FORGET THIS STEP!!! Stair Riser Install Tip — step-by-step moments | Oak Valley Designs

Subscribe for exclusive updates

Be the first to know about promotions, new products, and sales.