Deck Stair Tread Installation (How To Replace Deck Stair Treads)
Video by The Honest Carpenter · 1 moment used in Oak Valley Designs's DIY guides · 7:17 long

Moments in this video
- 5:17–6:11 Fasten New Treads with Screws
From How to Stop a Stair Tread from Creaking and Shifting, Step 2: Secure Loose Tread Edges
Position the new tread onto the adhesive-coated stringers, ensuring an approximately 1/8-inch gap between the new tread and the riser board behind it. For fastening, always use screws (2.5-inch exterior grade screws are recommended) as they provide a much tighter and more durable hold than nails. Pre-drill pilot holes with an 1/8-inch drill bit, aligning them with the center of each stringer. This prevents the wood from splitting when the screws are driven. Use an impact driver to drive the screws in, countersinking the heads slightly below the surface of the tread. For the front edge of the tread, where the stringer's wood grain might be sketchy or prone to splitting, carefully drive a screw into the riser board below instead of the stringer for a more secure connection.
The guide that use this video
More from the Oak Valley Designs DIY Hub
Read the guide Browse all guides
Planning this project? Shop Oak Valley Designs.

