Peel and Adhere Strip

What happens in this clip

The abrasive strip has a wax paper backing that protects the adhesive. Locate a corner of the strip and carefully peel off this wax paper backing to expose the strong adhesive layer. Once the adhesive is exposed, carefully turn the strip over. Position the strip on the stair tread, aiming to keep it approximately 1 inch away from the front edge (the nosing) of the step. This placement is crucial because it aligns the strip with where foot traffic is most common. Once positioned correctly, press down firmly along the entire length of the strip to ensure it adheres securely to the stair surface.

Goal: Securely attach the anti-slip strip to the stair tread.

What's used

Tools

• Cut Abrasive Anti-Slip Strip Unspecified

About the full video

This project provides instructions on how to install abrasive anti-slip strips on exterior stairs to prevent slips and falls. It involves selecting the right type of strip, measuring and cutting it to size, peeling off the adhesive backing, and carefully applying it to the stair treads.

Step 3 of 5: Install Anti-Slip Tread Strips

Cut the anti-slip tread strips to the desired length to fit each stair tread. Ensure the stair treads are clean and completely dry. Peel the backing off the adhesive side of the strip and carefully position it on the stair tread, starting from the front edge and pressing firmly towards the back. Use a roller or a hard-edged tool to ensure maximum adhesion and to eliminate any air bubbles. Repeat for all stair treads.

Open this step in the guide

Every video in How to Make Concrete Basement Stairs Non-Slip

1. Step 1: Prepare the Concrete Stairs

   • 1:13–1:37 Prepare the Surface
   • 0:28–1:00 Prepare Rough Concrete Steps for Resurfacing
   • 1:13–1:50 Apply Cleaner to Stairs

2. Step 2: Apply Anti-Slip Coating

   • 2:27–3:10 Apply Paint to Stairs
   • 0:46–0:59 Spray Clear Anti-Slip Coating
   • 0:51–4:06 Apply Adhesive-Backed Anti-Slip Products

3. Step 3: Install Anti-Slip Tread Strips

   • 0:02–0:06 Apply Anti-Slip Strip
   • 0:20–0:45 Peel and Adhere Strip (this video)
   • 1:12–1:19 Prepare Steps and Apply Non-Skid Strips

4. Step 4: Apply Textured Paint

   • 2:27–3:10 Apply Paint to Stairs
   • 10:24–11:30 Final Paint and Allow to Dry
   • 0:20–0:31 Painting the Staircase

5. Step 5: Cure and Inspect

   • 1:23–1:32 Allow Coating to Dry and Enjoy the Renewed Surface
   • 1:23–1:28 Allow Coating to Dry
   • 1:49–2:10 Allow Coating to Cure and Verify Non-Slip Property